2F Head bolt thread chasing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 12, 2013
Threads
25
Messages
522
Location
Old Fort N C
I need to chase the threads in the block of a 2F, I don't have a spare bolt to turn into a chaser.
I have found several 13x1.75 bottom taps on line, is their a favorite among the gurus?
Thanks in advance
 
I have always avoided actual taps. In my experience they tend to remove some of the material and make the threads slightly looser. I strongly recommend you buy a used head bolt, cut some vertical slots in it and use that.
 
I need to chase the threads in the block of a 2F, I don't have a spare bolt to turn into a chaser.
I have found several 13x1.75 bottom taps on line, is their a favorite among the gurus?
Thanks in advance

I have a few extra head bolts I can spare. If you would like, send me a PM with your addy and off they will go.
 
Back
Top Bottom