2f carb jet placement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 20, 2002
Threads
99
Messages
310
Location
Coeur d’Alene, Idaho
Rebuilt my stock carb this weekend.

Got a little anxious and removed the jets without noting which ones went where.

My manual just points at a tiny picture of a jet and calls it the primary and secondary.

Can anyone clue me in as to which jet is which? Which numbers should be stamped on each? One has an obviously larger hole than the other.

Same questions for the long smaller jets with the long tubes that go down into the carb.

Thanks!
 
I believe the secondary main jet, in addition to being chromed is also marked with "80".
HTH
Ed
 
Secondaries are bigger than primaries.
Your primary might say 1.18 on it, secondary should be in the neighborhood of 1.80.

Jets in tubes? The slow jets? Did you mix those up too?
 
If the other jets are the slow jets, then yes I mixed them up see the sketch below.
carb.GIF
 
Haynes calls those slow jets.
Also says (for U.S.):
Primary: 0.5
Secondary:0.8
 
Yup, sizes are in mm. Should also be stamped on the head of the jet...
 
Back
Top Bottom