1997 Getting Hot

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 16, 2012
Threads
1
Messages
6
I just purchased a ‘97 model. After driving it for about 25 minutes, thr temp shoots up. Coolant in the reservoir is boiling. It doesnt do it when the motor is just idling and doesn’t do it every time you drive it.

It had a new water pump and thermostat put in just before I bout it. I’ve added a gallon of coolant/water.

Any ideas? I’m fearing the worst.
 
Last edited:
Check under the oil cap. Look more like a milkshake than lubricant? Yep, it's the head gasket...

But at least you'll get that worry out of the way early in your new relationship.
 
Check under the oil cap. Look more like a milkshake than lubricant? Yep, it's the head gasket...

But at least you'll get that worry out of the way early in your new relationship.
No. That is NOT a sign of bad head gasket. It just shows there is condensation on there due to not being driven enough to evaporate the moisture out of the oil.

You should do proper diagnosis to correctly identify a head gasket

Compression test
Leak down test
Coolant exhaust gas test
Blackstone oil analysis.

If any of those confirm failure, then go after the HG.
 
How old is the radiator? This would be my first step. I had a similar issue - about 20-30 minutes of driving and I would start to get "warm." Radiator fixed this issue. My old radiator did not appear to be clogged with debris, but I haven't had any issues since I replaced it... While you're in there, might as well change out your fan clutch with an OEM blue one. You should also check the condition of your coolant hoses, sometimes they can collapse.
 
After doing some more checking, the oil looks good and the radiator is only 2-3 years old. And after driving it a little today, I have not lost any fluid. I am thinking I need to try to replace the thermostat even though it is new and see if that has any effect. It’s a pretty cheap easy try. If it doesn’t, I’m thinking cracked or warped head or head gasket and time to find a good mechanic.
 
After doing some more checking, the oil looks good and the radiator is only 2-3 years old. And after driving it a little today, I have not lost any fluid. I am thinking I need to try to replace the thermostat even though it is new and see if that has any effect. It’s a pretty cheap easy try. If it doesn’t, I’m thinking cracked or warped head or head gasket and time to find a good mechanic.

My radiator was a “Koyo” that was only 2 years old and it turned out to be the issue. It was literally the last thing in my cooling system that I replaced before seeing if it would cure my overheating problems. Sure thing, new radiator solved my problems. Not saying it’s the problem in your case, but don’t rule it out just because it’s only 2-3 years old. A radiator cap is a very cheap item and plays a very important role in a cooling system as well — if you’re trying to rule things out beginning at the cheaper end.
 
My radiator was a “Koyo” that was only 2 years old and it turned out to be the issue. It was literally the last thing in my cooling system that I replaced before seeing if it would cure my overheating problems. Sure thing, new radiator solved my problems. Not saying it’s the problem in your case, but don’t rule it out just because it’s only 2-3 years old. A radiator cap is a very cheap item and plays a very important role in a cooling system as well — if you’re trying to rule things out beginning at the cheaper end.


Thanks! I’m learning a lot here. This forum is a huge help.
 
Get a ODB 2 reader and see what you temps are and what causes them to climb. Idle and slow traffic speeds or under load highway driving. At this point is could be anything but just replacing things willynilly would be foolish and $$$. Sorry but not every problem is a head gasket. Been around cruisers for decades and have a group of trucks we run with a I have personally never seen a head gasket problem. Have encountered many other reasons for overheating. Easiest is bad cap that doesn't allow pressure to build.

You can also test radiator fluid for Co2
 
No. That is NOT a sign of bad head gasket. It just shows there is condensation on there due to not being driven enough to evaporate the moisture out of the oil.

You should do proper diagnosis to correctly identify a head gasket
SNIP

It may not be definitive, but it's certainly indicative. You'd definitely want to investigate further if you see this.

If the truck has been driven and not sitting, it's likely not simply excess moisture...
 
@wilburthom ... my 97 showed many of these same come and go symptoms before the head gasket finally gave way for good. It was leaking compression gasses into the cooling system and would lose coolant slowly on a random basis. All the above advice is solid, especially getting an ultra gauge or scan gauge to monitor coolant temp in real time, that will be the easiest indicator of the head gasket problem and will allow you to save the truck from further damage. If you see temp swings above normal operating range (mine was 185-197*F) then you really need to be careful. The stock gauge is crap for looking at real operating temps.

I tried a tester like this and it showed a positive result and then the HG gave way fully (puking coolant out the exhaust) a couple of weeks later.
 
It may not be definitive, but it's certainly indicative. You'd definitely want to investigate further if you see this.

If the truck has been driven and not sitting, it's likely not simply excess moisture...
The key to your statement is: "If the truck has been driven".

As the majority of these trucks are driven for weekends only then sit most of the rest of the time, there will be condensation under the cap of nearly all of them.

I personally know of three people that have torn into their engine, convinced they had a blown head gasket because of this statement. Many of those that come to this site looking for advice are less than :banana: mechanics, but they want to be :banana::banana::banana::banana:

I disagree with this being a diagnosis tool.
 
Get a ODB 2 reader and see what you temps are and what causes them to climb. Idle and slow traffic speeds or under load highway driving. At this point is could be anything but just replacing things willynilly would be foolish and $$$. Sorry but not every problem is a head gasket. Been around cruisers for decades and have a group of trucks we run with a I have personally never seen a head gasket problem. Have encountered many other reasons for overheating. Easiest is bad cap that doesn't allow pressure to build.

You can also test radiator fluid for Co2


It can idle and not get hot for hours. Driving it takes 20-30 minutes before you see issues. I have use a thermometer to test intake and output hoses on radiator. It appears to maintain 10-12 degree difference. Can also tell that the thermostat is opening an closing when idling.

I will test for CO2 and replace the radiator cap and go from there.

Thanks for the help!
 
If it doesn't overheat when idling there may just not enough engine pressure to force emission gasses through the leak and into the coolant. If you haven't taken off the radiator cap yet and let in any air to the system you could look for bubbles from the tube in the overflow bottle while keeeping the engine reved at 3000rpm. Keep the overflow tube end submersed in the coolant so it doesn't introduce air to the system and glance down into the overflow bottle. If there is a steady stream of bubbles or air from the tube it indicates a leak somewhere and the HG could be it. The other tests of course mentioned already are more definitive but this is an easy test to do without any equipment.
 
The key to your statement is: "If the truck has been driven".

As the majority of these trucks are driven for weekends only then sit most of the rest of the time, there will be condensation under the cap of nearly all of them.

I personally know of three people that have torn into their engine, convinced they had a blown head gasket because of this statement. Many of those that come to this site looking for advice are less than :banana: mechanics, but they want to be :banana::banana::banana::banana:

I disagree with this being a diagnosis tool.

Hmmm, well your truck may sit, but mine gets driven, not daily, but multiple days a week.

BTW, I wasn't referring to mere moisture - not at all a sign - but to the oil itself having that milkshake look, two rather different appearances to me in my experience.

If this popped up, I'd certainly be looking into it, although I agree not enough BY ITSELF to tear down a motor. Neither were several other things mentioned. Thing is, you look for clues at the beginning if you have overheating, then you advance to a test kit or a mechanic if you can't resolve the issue.

Maybe Mr. T should have put something like those turkey "thermometer" pop-ups on top of the engine? When the red stick pops up, you head gasket is done... :oops:
 
Last edited:
Hmmm, well your truck may sit, but mine gets driven, not daily, but multiple days a week.

BTW, I wasn't referring to mere moisture - not at all a sign - but to the oil itself having that milkshake look, two rather different appearances to me in my experience.

If this popped up, I'd certainly be looking into it, although I agree not enough BY ITSELF to tear down a motor. Neither were several other things mentioned. Thing is, you look for clues at the beginning if you have overheating, then you advance to a test kit or a mechanic if you can't resolve the issue.

Maybe Mr. T should have put something like those turkey "thermometer" pop-ups on top of the engine? When the red stick pops up, you head gasket is done... :oops:
No, mine is a DD. Approximately 20k miles/yr.

My point is, for those that don't understand proper HG diagnosis, this isn't anywhere close to a definitive answer.
 
No, mine is a DD. Approximately 20k miles/yr.

My point is, for those that don't understand proper HG diagnosis, this isn't anywhere close to a definitive answer.

No, and most signs of HG failure sneaking up are similarly not definitive. You start adding things up and looking deeper into things. I sure don't have the money to take it to the shop at the first potential sign of HG failure. I need to know there's a reason to spend that kind of money.

Fortunately, I have a mechanic who is smart and honest enough to give me the bottom line on what the source of a problem is if I bring it in and tell him what I think might be wrong. I suspect that the issue with people jumping into unneeded HG repairs may be as much shops with $$$ in their eyes when someone brings in a Land Cruiser with an overheating problem. Or someone with more shop, tools, and time on their hands than I have.

But even with a reliable mechanic or a personal garage, I simply would not start on a HG R&R without a definitive test, whatever calls my attention to the fact that there's a problem somewhere. I think we can agree on that, no matter how we got to that point.
 
Back
Top Bottom