1991 FJ80 headlights

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 31, 2015
Threads
45
Messages
197
One headlight just went out. Brights work fine, but it looks like they're separate so I think it's good.

What headlights do you use? Any to avoid?

Any friendly tips for changing the bulb? It looks like it's just two silver hexes on top to undo and then the plastic pulls off.
 
No.
 
I use these in both the low and high beams. Takes 30 seconds to trim the one tab. You can use a razor knife, file, or grinder to trim it. Then plug them in. They are most excellent.

They say they are Wagner brand but Phillips 9011s show up.

IMG_3758.webp
 
Be very particular when trimming the tabs. When I did this, I ended up with one that would not stay put without the help of a wire tie.
 
Be very particular when trimming the tabs. When I did this, I ended up with one that would not stay put without the help of a wire tie.

I just trimmed it a little less than needed. But one I overtrimmed. I think you may have an issue with the receptacle side. Try it on your parts rig.
 
I just trimmed it a little less than needed. But one I overtrimmed. I think you may have an issue with the receptacle side. Try it on your parts rig.
That was in my parts rig, literally 24 hours before I rolled it. The White Rhino sports Depo's with h1 and h4 lamps. :D
 
One headlight just went out. Brights work fine, but it looks like they're separate so I think it's good.

What headlights do you use? Any to avoid?

Any friendly tips for changing the bulb? It looks like it's just two silver hexes on top to undo and then the plastic pulls off.

The bulbs are replaced from the backside of the housing. You don't remove the front trim. On the passenger side you need to pull the coolant overflow tank up, to remove it off it's bracket and set aside. Rotate the blub 15 degrees counterclockwise to loosen and pull out of housing. No tools are required.
 
The bulbs are replaced from the backside of the housing. You don't remove the front trim. On the passenger side you need to pull the coolant overflow tank up, to remove it off it's bracket and set aside. Rotate the blub 15 degrees counterclockwise to loosen and pull out of housing. No tools are required.

Thanks for pointing that out. I read that I had to actually use tools for this...you just saved me a lot of trouble!
 
I use Silverstar Ultra bulbs. They work fine for me, are tons brighter than the bulbs they replaced, and are plug and play. Just be careful to not touch the glass bulb when you install them (wear rubber gloves). Your finger oils will do them in prematurely.
 
Philips HIR2 3d Generation 9012

This is a good thread regarding HIR bulbs.
I purchased sets from candlepower.com
9012 is low beam-replaces 9006
9011 is high beam-replaces 9005

They work exceptionally well in all conditions.
 
Back
Top Bottom