GM 1968 C10 stepside shortie build.
- Thread starter darwink1
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Is that a harness and ECU or just a harness that works with your stock ECU?
- Thread starter
- #404
Just a harness. This one is for dbw and a 4l80 but there's dbc and/or 4l60/manual options.
D
Last edited:
- Thread starter
- #405
My buddy Gil used one on his c20 4x4 and recommended it. He said they're not without their faults (his had a few plugs pinned incorrectly) but it worked mint otherwise.
Hoping its easier to deal with than my crusty and greasy stock harness. I paid another buddy $500 to stand alone (and tune the ecu) the one in the 40 so the Amazon ones are cheap by comparison at $256 cdn..
D
Last edited:
- Thread starter
- #406
From a perfectly running truck one minute to a non running pile the next... Cool.
D
D
- Thread starter
- #407
Fuel lines, trans/motor mounts and beep boops to go. I think.
D
D
- Thread starter
- #408
Heading out to buy floor dry now lol.
D
D
- Thread starter
- #409
Too many things happened. I'm hungry and a little sleepy .
Big thanks to @shane_cadger and no@armysteve for the help today!
D
Big thanks to @shane_cadger and no@armysteve for the help today!
D
- Thread starter
- #410
D
- Thread starter
- #411
D
- Thread starter
- #412
Dumping pictures like a truck...
D
D
- Thread starter
- #413
Found a couple pics of this pile in it's previous life.
D
D
- Thread starter
- #414
Oh and I got a little artsy and crafty last light... after scrubbing/squeegeeing the garage floor to get the ground in floor dry off and shoveling 4" of damn snow.
D
D
- Thread starter
- #416
Gross right? That bed is the reason I scrolled right past this truck for 2 months when I was looking..
D
- Thread starter
- #417
Removing the stock motor mounts at the frame was fun. There's no captured nuts under there and the only way to get a wrench on any of the nuts is through the lower control arm mount.. hole.. Found the drill some big holes trick on youtube and it worked mint to get a wrench in there. Worked even better when bolting the ls swap mounts in.
Also took the battery tray out as I'm thinking of relocating the battery to the rear under the bed somewhere. Ordered a billet aluminum optima mount from Amazon the other day so I can mess with that when it shows up.
D
Also took the battery tray out as I'm thinking of relocating the battery to the rear under the bed somewhere. Ordered a billet aluminum optima mount from Amazon the other day so I can mess with that when it shows up.
D
- Thread starter
- #418
D
- Thread starter
- #419
The rad support is shedding a little in one spot but its still solid.
D
D
- Thread starter
- #420
D