100 Series General Tech and Classifieds
- Thread starter wngrog
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2,943
I have the wind deflector in and some foot thing for the rear.
Very nice quality piece.
Which rack is that?
Frontrunner
- Thread starter
- #2,946
Another hour to get feet on and up on the truck square. Probably took another hour to tighten all the nuts since I had to do that with a hand tool.
My 3/8 snap on made the assembly much easier than by hand.
I could do a second one in 1/2 the time.
Love it. Looks awesome.
Plastic sunroof wind thing has to come off FYI. I gotta scrape the 3M tape off and I'm finished
My 3/8 snap on made the assembly much easier than by hand.
I could do a second one in 1/2 the time.
Love it. Looks awesome.
Plastic sunroof wind thing has to come off FYI. I gotta scrape the 3M tape off and I'm finished
- Thread starter
- #2,950
I just tossed the stock rack in the dump. It's there.
- Thread starter
- #2,955
Last edited:
Wow, that's nasty. I use either a heat gun or blow dryer to soften the glue before I try to remove it. I find more comes off leaving a little easier job. You might try a soft plastic scraper (like from the kitchen) and a little heat from a blow dryer to see if you can get a little more off. Then soak some strips of rags in WD40 and let it soak for a bit. That should soften the adhesive.