torque

I am about to put the cylinder head back on after a headgasket replacement. Bolt holes look clean and thread in without a lot of friction. I plan to use new OEM head bolts oiled per FSM. Reading on mud some say to chase the threads. FSM does not state to do this. I plan to run my bolts down each...

Does anyone have the torque specs for both oil pans for the 1FZ-FE? Or know where I can find these, my repair manual isn't much help and my school's All Data also doesn't have it either, so I figured I could ask ya'll

whats the torque for castle nut on tie rod -- cant find it - thanks - thinking 65 lbs but not sure

I'm new to this app and obd diagnostics in general. I'm not getting anything on trans temps when I connect. Is there some way to add this function, or does my 2000 not have a temp transmitter?

where would i find all the torque specs for the whole car? I'm replacing my upper and lower control arms and need torque specs for the calipers, upper and lower control arms and all that and also it would be nice to know for future reference.

Selling the trans, transfer and converter from a 96 lx450. $550 for all 181k. Good condition. Prefer local pickup, but will drop at fastenal for freight. Buyer makes arrangements. Rolling chassis also available.

Hello all, newbie here. I recently purchased a 99 LC and will be installing the 2.5" OME lift this weekend and was hoping someone may have the torque specs handy for the front/rear shock bolts, torsions bars and any other nuts/bolts I maybe needing to torque in this process. I searched the 100...

So I was retorqueing the wheel bearings in my 60 and I came across something interesting. While chatting with Kurt at Cruiser Outfitters he mentioned the torque values being 6-12lbs (rolling friction + 6-12lbs). In my 1984 FSM it states 0.9 - 7.3 for the the same thing (page FA-15). I called him...

I need a torque converter for a LC 1992 3FE (4.0) trans A440F. I am located in Charlotte NC.

Well I have searched the vast expanse of the forum and internet, only to come away still confounded. i am trying to mate the engine and transmission, ensuring the flywheel bolt holes and torque converter bolt holes align. My son and I can't seem to crack this particular nut. 1. Is there a...

The water pump on my '92 (175k miles) finally gave out, so I'm replacing the thermostat while I'm in there. Thanks to @beno for the parts, super-fast shipping, and helpful advice on the project. The FSM says that the 4 bolts that hold the thermostat housing together need to be 13 ft-lbs, but...

Hey gang....Just installed an entire new SOR Heavy Duty Suspension 3" Lift Kit on my 85 Fj60. I added the Skid plates, they seem pretty burly..hope that they do well. Read some old reviews about it after the fact..so if they suck, I am gonna change to the Bolt flip kit from 4+plus. Cleaned...