montana

Not sure of the best place to post this. I'm headed west Aug 28th on a two week trip. Leaving IA heading west to SD, WY, MT, and ID. Will likely be stopping in: Rapid City, SD Sheridan, WY Jackson Hole WY, Yellowstone area Coeur d' Alene Everything else is up for grabs. Ample time to explore...

I’m planing on getting a TLC 77 and from what I can tell is going to be hard to register it in CA. I was wondering if anyone out there has gone trough a Montana LLC to register the truck in Montana and be able to drive it in CA? Thank you

Need some advice. My daughter lives in Missoula, I am down here in Phoenix, and need to find a shop to look into an issue. She is being told it is a wheel bearing. No way for me to know here. She has a 2004 V8 sport 4runner, 4x4. She is in school and I need to use someone that can be...

If you were to spend $15k on a 40 rebuild (Trail Comfortable and Reliable) where would you go? Only Mountain West Vendors please. Closest to Bozeman will get preference for obvious reason. Thanks! Ryan

I purchased a non running 80 series in Red Lodge. The original shipping company I booked has bailed after two weeks of vehicle issues. I'm not in a large rush but would like to move the vehicle off the sellers property and get it on its way to my house. Let me know if you guys can help, Brian

Hi gang. It's time for me to head south again, so I'm selling my Cruiser. I have had it since May and have put about 10k miles on it with no problems. It currently has 256,7xx miles. It does leak oil from the bellhousing/tranny window, which I assume is the oil pan arch seal. I keep it...

After a slow-motion search that started in 2007 and featured a couple of states and a few false starts, I pulled the trigger on a '77 just a couple of miles down the way back in August. The PO's kids called her "Fern," and it seems like bad karma to change the name, so Fern she is. 62k on the...

Looking to trade my FJ80 ARB Winch bumper for a Metaltech Tube bumper of equal condition with big stinger - straight up trade. ARB Is in good condition no dents just 2-3 spots where the paint was rubbed off. I am located in Northwest Wyoming, Willing to travel a few hours but not extremely far.

Looking to trade my FJ80 ARB Winch bumper for a Metaltech Tube bumper of equal condition with big stinger. Would also be interested in selling the ARB for cash if anyone is interested. ARB Is in good condition no dents just 2-3 spots where the paint was rubbed off. I am located in Northwest...

I spotted this in the Bozone yesterday. Local plates. Somebody here? I woulda left a note, but didn't have any paper. What rigs have you seen around Montana?