I need a lower right rear spring plate, the part that goes under the spring with the lower shock mount. From a 1990 or newer 70 series. This has the shock mount on the back side of the spring plate, not the front side of the spring plate. I am installing a rear sway bar and the forward...
I think I better change it before it decides to change itself.
1991 FJ80 with 3FE engine.
Some pictures I'm seeing it looks like there are two hoses, with a note about engine to pipe and radiator to pipe, that was at the NAPA store today and looking online. Other places online it looks like...
Bushings on my 08 GX470 (178K) are dry and cracking. Looking into options to replace the bushings or the entire lower control arm and just start fresh.
Trying not to break the bank on the replacement. Any suggestions for brands to look at and/or tips for the replacement?
New, never installed. Comes with everything you would get when ordering from Metal Tech. Retail is $499 plus shipping. I am selling for $400 plus shipping. Pick up is available. I've owned them too long to return to Metal Tech.
I need to replace the trim piece that runs below my radiator grill. I took various advice from this board and located the part number for my ‘02 Land Cruiser in 6Q7 (Imperial Jade Micah). I am now having trouble locating this part (5390360040) in the same color.
I figured I would ask advice...
Hello,
I'm looking for both rear lower control arms and the lateral link from a 100 series. Bushing condition doesn't matter. Links must be straight. Located in Monterey, CA. Will drive a bit to get them.
Thanks.
My brother just acquired a really nice low mileage 1982 Toyota 4x4. The problem is the lower valance was missing. It seems to be in doing a quick google search they are very rare, even aftermarket. Any of you guys have any help on where to locate one?
Does anyone have a cheaper source of rear lower control arms? For new parts, ebay is the lowest at around 160 per side shipped. I've also checked Partsouq and rock auto. I'd be fine with remanufactured, but couldn't find that option.
Thanks
First sample received today. Will test fit for compliance. Very happy with it. I've had these made out of a better Alloy than the original. Will last longer. More tolerant of additives etc.
Lower housing has the double boss for the BVSVs used from 1978-1980. Upper housing is the earlier flat top (vs the 79-80 angle-top. Pretty good shape overall, with three pits in the neck of the upper housing about 1/8" across.
$195 plus the ride from Burbank.
Who has done a high steer and has leftovers. 78-90 cruiser or mini will work.
Aka large pattern. Need multiple sets to complete some disk brake conversions I'm putting together. Either mini or cruiser taper is fine. Prefer not drilled thru for heim.
Need regular arms and lower caps. Someone that...