fj62 engine

  1. L

    FJ62 Replacing Fuel Filter Due to Stalling

    Hi all, I will be replacing my fj62 fuel filter due to stalling issues that may be led by a bad fuel pump, but first I want to replace the fuel filter to cross that off as a culprit. I have other threads about originally thinking it was the battery and replacing all components, also replaced the...
  2. L

    Replacing Fuel Pump FJ62

    Hi all, so after a lot of forum reading it sounds like I might have a bad fuel pump OR bad fuel pressure regulator.. here are the symptoms I have, but long story short I want to know if it’s possible to replace the fuel pump with out dropping the entire fuel tank? I saw a step by step video on...
  3. L

    FJ62 Intermittent stalling

    Hi all, I have previous threads about having stalling issues and others said to replace the battery, the terminals, and the cables. I replaced the positive fusible link, and the entire negative battery line along with terminals and battery. I drove it afterwards with headlights, radio, heat, and...
  4. julianramirez1005

    Build  Julian's 1989 FJ62 Build

    Hello Everybody, Starting off I will be referring to the donor vehicle as Rusty and the Chassis I am transplanting into as Scooby. Going to be pulling the 3fe (151k original miles) from Rusty this weekend fingers crossed. Never pulled an engine before but I am very excited to dive in. I am...
  5. L

    1989 FJ62 Land Cruiser EFI Relay Start Issue

    I recently purchased this car and pretty much everything is great on it and starts up at a cold start great, only thing is that when i go run errands, after about the third stop of turning the car on and off the engine will crank but not start then after about 30 mins it will start. I put this...
  6. J

    Wanted  3FE Distributor Wanted

    I'm looking for a replacement Distributor for a 3FE motor. Looking for an aftermarket since OEM long ago ran out. Got a CLE code 12 and resistance that was out of range when tested. Can anyone point me in a direction to find one? I've looked at new aftermarket ones. Any advice if I...
  7. MCJakeCrim

    Help with 3fe crankshaft front main bearing cap bolts. Cant get a wrench or socket on them.

    Guys, need some help with these 3FE front main bolts. Can't get a socket on them at all, can't get a good bite with a wrench. Do I need to go buy a crows foot? The cap gets in the way. They're monster tight and my open end wrench just bends and loses bite.
  8. FJ40 MATT

    Parting Out  Parting out a Running 89 FJ62 w ARB Bumper & 189k Miles in New Jersey

    Hey I’m going to start parting out a 89 FJ62 this weekend that runs and drive but has no brakes. All “4” windows go up and down with their switches on the door and the main switch panel on the driver door. The front wipers work well and so does the rear wiper motor work on both speeds. The...
Back
Top Bottom