Wheeling weekend and trail carnage! (no pics. . .sorry)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 11, 2004
Threads
53
Messages
239
Location
So Cal
Wheeling weekend and trail carnage! (no pics. . .sorry)...And questions!!

Jumping over from the 60 and 80 forums after a Great weekend wheeling up in big bear in so Cal. Beautiful weather, took both kids (wife stayed home as she is 9 mo. pregnant). Went with a buddy who's wife is also pregnant (we are the dads of the year). anyway, 3/4 of a mile from the end of the weekend was going up an embankment and jumped up on a tree trunk sticking out. Came down on my rear output shaft and busted my pinion. The thing then slid into the axle housing and jammed up in there. (BTW, using a 1972 fj40 (which I previously sold, but was using for the weekend-of course you break what is not yours-).
so, on the side of the hill with no where to go and the rear wheels bound. I have to say that the most embarrasing part of this story is that my buddy had to tow me with his 64hp suzuki samuri (which is regeared and ARB'd front and rear-very nice samuri). we got it to a workable place and luckily two guys in full size chevy's stopped to help. Turns out both were mechanics! Great guys. Help on the trail is always very cool.
so, here i am, I've got ten days to fix the cruiser. I have an extra set of axles, one without a pinion and one with (however, I'm not sure they are geared the same as the one I broke) broken one was 4.88 I believe and don't know about the extra set.

The output shaft seems fine, I just need a new pinion and then to reset the axle (backlash and all of that)

I am sure that I am missing something. I might not be seeing everything, I'm sure I am not. I'd love it if you guys could ask me some questions and give me some pointers.

thanks
tjg
 
Last edited:
I know I know. Getting out on Saturday was a bit of PITA. Barely made it out, 2 hours on the trail and realized there was no camera. Will post pics of the pinion and shaft this afternoon.

duly chastized!
tjg
 
gillti said:
The output shaft seems fine, I just need a new pinion and then to reset the axle (backlash and all of that)


Almost went to chat....


What the hell are you talking about here? The output shaft??? Are you talking about the drive shaft?


You will need a new 4:88 gear set, both the ring and the pinion, as they are a matched set.




:beer:
 
Poser, thank you for your input. I guess I am talking about rear driveshaft. My mistake. Thanks for your patience.
I believe the axles are out of a 1978 fj40, would that have come with 4.11's on it. I'm searching and trying to come up with as much information as possible.

I apologize for not having all the correct language here, still trying to get a handle on all of this. these boards are so helpful, not trying to clog them with inexperience.
 
Stock gear set in a 1978 would be 4:11....and would have a fine spline pinion to boot....not as common a 4:11 gear set as the coarse spline.

Any 4:11 gear set will work, or make life easier on yourself and find a whole center section and swap that out....just make sure you get the four speed bolt pattern companion flange on the diff.


We are all out here to learn bud!


:beer:
 
Thanks Poser. been searching again, just let me check one thing. I need to count the teeth on the pinion and the ring to make sure of my gearing, correct?
 
Much Better. thanks. Will post pics of the damage later today.
tjg
 
Back
Top Bottom