I bought a 2000 Volvo V70 about a year and a half ago to replace my old 94 Land Cruiser due to gas prices. I was always frustrated by the lack of cupholders and the height of the standard center console in the old Land Cruiser. I now own another 94 FZJ80 that I am converting to diesel, while looking at the console I had a thought that the console lid (with cupholders) from my Volvo just might fit. I pulled the lid off of the Volvo and it was close but didn't fit. I then set the lid on top of the existing lid on the Land Cruiser and it looked pretty good. I went ahead and ordered another lid on ebay and now have it installed (search for V70 cupholder). I installed it with screws from the bottom, I had to grind a little piece off of the bottom to get it to fit flat but other than that I just set it on. Not sure if the height is ok but it did bring it up about 2-3" which will help. I may raise it another inch or two after I have driven it a bit. I have been really pleased with these cupholders in my Volvo, the only problem is that you can't open the lid with drinks in it. All in all I think it is going to be a good addition and I think it actually looks pretty good!
Here are some pictures so you can see what I am talking about.
Rusty
94 FZJ80 mid 6.2 diesel conversion
Here are some pictures so you can see what I am talking about.
Rusty
94 FZJ80 mid 6.2 diesel conversion



