Recent content by Willys43

I will probably show up Sat to help Amanda harass you!

Looks like a very handy lift ya got there Kelly! Where's the thread on the Colorado Adventure?

I know where there is a Mog sitting in a field. Dont know anything about it just where it is!

ill be there

Charlie, I have a press, get the parts and we can press them in

When it runs maybe

I think that might be my title

Full frame vehicles do not crush the same way unibody vehicles do.

Haven t got a clue what I need or what I might do, but Ill keep it in mind, thanks

Kelly, you may be able to put a gusset at the top corners after fitting the seats. Not as good as diagonals but better than tube only. Also you might want to use heavier tube wall on the outer hoop only.

From what Ive been reading just putting a tube down the frame and back to the front will do. I ll probably build the system and monitor temps to see what might be needed

I just looked up when skin burns. Less than 1 second at 175 degrees. We dont have the ability to tell if ps steering is too hot by touch. It will burn us when its operating normally. Im interested just because Im accumulating parts for hydroboost and ps for the Willys, cooler is an option. Im...

Kelly, I read 375 will melt the dipstick on the the cap, and seals and O rings in the pump. Also if ps fluid is running between 180 and 215 deg it would feel blazing hot yet not be over heated.

I read that 300 degreescwould fry pump. Thinner fins may dissipate more heat but definately not as durable

On or off road?