Recent content by Weng

The link was shot. The joint does not even hold itself. Time to replace.

Yeah, hope someone knows the solution to this problem.

There is a rattling sound behind the tacho gauge when it reaches 2100 up to 2400 rpm only. However, no rattling sound can be heard other than the mentioned rpm. The sound is like a metal clanking or like a gear teeth hitting something. It drives me nuts every time I hear it. Listen carefully...

Noob question. I noticed a tear on the stabilizer/sub-assy link rubber under the driver side. Do I need to replace the whole link or just replace the rubber? The link cost US$76 here in my country. Been thinking, maybe the rubber only cost a couple of bucks :D

here in the philippines, the model is HDJ80. 1hdt engine, 5 speed manual transmission and left hand drive

i'm using this https://www.amazon.com/gp/product/B010T3D1CQ/?tag=ihco-20

I find the ride of my HDJ80 slightly harsh at the rear using OME860 and Nitrocharger Sport 60020 shocks. My truck does not have a rear armour or added weights for reference. Will changing the coils to OME862 (plus spacer to level out) softens the ride? How about changing the OME shocks to Fox...

That's one bright DRL. Is that a direct fit or you did some mods to the hole in order to make 'em fit?

not that bright compared to the common LEDs but they're visible during daytime

bought them on ebay. the seller is 4wdstore from australia. @jonheld, not sure if this light is from a VW Jetta

replaced mine with a LED connected as turn signal light.

HDJ80 on 33" Cooper STT Pro

Replaced 2 ea engine and 1ea transmission supports in my '95 HDJ80 at 225k km. Big improvement on idling, reduced vibration especially when turning engine off. Genuine toyota support costs $60 each from where I live. I also replaced the rear control arm bushings :)

uneven spring height can be easily fixed using 2 different sized coil spacers. a friend of mine using an 851 spring fitted 1.5" spacer on the passenger side while around 2.5" on the driver side to get an even stance to the rear. it was a garage made spacer that looks like pipe (with diameter...

Oh by the way, driver side is LHD and my truck is perfectly balance with fuel tank half-full.