Recent content by Weezer

your gauge showing low oil pressure at idle is normal. I’ve two 4.7s and they both show low pressure at idle. Different Toyota techs have all confirmed this over the years.....you’ll get use to it.

It's really a rather simple install. The Aussie you tube is great and Phil's instructions on his install was really helpful. Take your time and be methodical. I did the install in my garage on the floor. I absolutely love PT on my 2000 LC. Gonna like it more when I can install Aisin hubs! I've...

I’m in....can I pre-order? My AVMs have been fine so far but would much prefer AISIN hubs!

The Mark’s PT kit cost me less than $600 US dollars delivered to Texas. Took me right at 5hrs to install in my garage. I had previously install new OEM axles and bearings. I absolutely love the PT. Much less vibration and super smooth at hwy speeds and of course, zero torque steer. I’ve had to...

Exactly. I've only had to add very little over the last year but I can imagine the boot(bellow) is full. Guess I need to remove the boot to empty it; then see what happens over a period of time. It's never leaked enough to hit the ground. I hate leaks of any kind!

Are you guys with rack leaks running without a boot when adding AT-205 so it's obvious if it stops the leak...or not? Mine has to fill up the boot before I know it's still leaking.

So I should be able to get a bit more. I’ll try that before I spend 600 plus on new UCAs.

Forgot to mention....I just installed new poly rack bushings also.

2000 LC with 1.5” lift over stock front with 30mm spring spacers rear. 1.5” rake. I’m running 275 70 18s with 40lbs pressure front and rear. Tie rod ends are new OEM. Ball joints and bushings are all tight. Wheel bearings are new and adjusted well. Toyota dealer aligned it today and was only...

Thanks. I've some fairly light Hellas that I'm wanting to mount on the bumper

Do you have brackets of some kind under the bumper where you've mounted your KC driving lights? They look really nice. If no brackets, do you get much vibration out of the lights. Very nice Cruiser!

Thank you sir.

I live in Texas. Would using Amsoil 80W90 Synthetic be ok in a transfer case? Would it be that much different than 75W90? It's what I used in my diffs. so I have it in my shop.

I know this is an older thread, but glad I found it. I just replace my heater Ts, all hoses and OEM thermostat. I filled it back up with T red in a 50/50 mix with distilled, de-mineralized water. Temp on my scangauge was running 187+or- a bit before the work. After the “work” it was running 200...

I did just that....clearcoat....until I can get back from my 1st trip with them. Who knows, may leave them “natural”.....they really are a work of art to me! Pics soon