Recent content by VTOLC100

DM me. I have, OME torsion bars, front and rear springs from 2000 LC 100 with 184k miles at change out.

Wondering if I could get some input on the following. A week or two ago I noticed the truck was pulling to the right and figured it might need an alignment after some fairly light trials so I got that scheduled. I then noticed that the driver's side rear wheel was projecting out more than on the...

I was getting a bit of hood vibration, so changed out the old hood seal which was pretty flat and worn compared to the new one. Not sure I needed new hood bumpers, but I put them on anyway. Also added some more lights on a hood switch, which give a good bit of light. Haven’t driven it yet to see...

I got some White Knuckles on, a Roof Rack, and some Lights!

Got an Auxbeam controller installed and a rechargable Fenix flashlight mounted.

I was looking for the ash tray delete bracket to mount my Scanguage III but it was sold out, so I decided to see what I could come up with instead. Some 16 Ga metal, three rivets and hour later I had a bracket! Originally I was going to use an adjustable bracket from an Auxbeam switch that I had...

Trying out a little makeshift wireless charger setup.. So far so good for less than $20. I cut down some hard foam packaging I had laying around and just laid it in there and put a bar stop at the bottom with double sided tape to butt the phone up against and two side stops (they need to be...

Yes, I pulled the EFI relay and let it sit for 10 minutes, and then started it and let it warm up. I think it had to do with the severe cold and possibly some water getting frozen after I washed it the previous evening. Had no problems this past weekend in cold conditions. The ECT power and 2nd...

Here are a few more photos. I since took of the fender flairs and didnt use any spacers but these had a 25mm offset. I did the Ironman lift kit which raised the stance. Don’t think it would have rubbed but I had done the pinch weld fold before putting the new tires on.

@landocalrissian I’m running the Crutchfield harness to the Amp but have a question on the S7 connector. In the points above, did you remove the pins on the existing S7 connector originally going to the Amp and tie them to the original S6 connector and then you connected the Metra harness to the...

That's in the plans, too, but I have at least one busted speaker that I can't take any longer!!I'm hoping on their site now. What head unit did you choose?

@krice118 - I think I will get the same speakers as you! Did you replace the tweeters, too, and if so, what do you go with? Thanks

@txtuffluck Did you ever go with the Gobi X or ARB and if so how do you like the setup? I’m looking at the same two plus Valley Tech. Thanks

I noticed the other day I had one of these on a shelf and it just occurred to me from this post that these might work well for a grab handle also. Not as cool as paracord thought!

Found this online; Rear washer nozzle removal.Use two tools front and back to pry it up. Disconnect the hose inside the rear gate first and push it up a bit in the rubber boot as the hose just peeps out of the top and its can otherwise fall inside the cavity leaving you to have to fish around...