Recent content by Urtwob

Thank you Badlander. Very much appreciated, I was concerned I had damaged a small liner in the hole. Relieved.

Hi Guys. Thankfully I’ve never needed to swap out any of my ABS Sensors on my 1998 4.2 VX RHD LC100 Amazon, until now. I have looked but I can’t find a detailed thread on doing this job. I need to replace my LHS Passenger side Front ABS Sensors I was also changing my front wheel bearing at...

A Million Thanks my friend.

Hi Guys, can anyone point me towards links on IH8MUD or pages, or even videos anywhere such as YouTube etc re the removal of the Wiper linkage on a 1998 LC100 4.2VX. Thank you.

Hi There Can I ask what effect the Rear Axle Diff lock has on the ABS System. The rear diff on my cruiser is in awful shape, very badly rusted and it does not work when turning the switch to lock rear axle. I have read somewhere today that the rear diff lock is relevant to ABS issues. Thank you.

A million thank you’s Ianierchris. I really appreciate your reply. And am truly grateful for your offer of further assistance if needed. I will start and go through the steps you have outlined and if still in difficulty I may come back to you for more direction. Truly appreciated.

Hi Guys, ABS has not functioned ever since I bought this cruiser 9 years ago. (1998 LC100 4.2td vx. ) Just recently I have, via the help of a friend, got TechStream up and running with the full compliment of features. I went in to look at my ABS system and it has thrown up two Codes. C 0205 and...

Hi 2001LC. I’m with you all the way re keeping this rig back to factory spec. I’ve been doing quite a few minor renewals of suspension parts etc and I hope to have all the running gear renewed where needed before I take her off the road for a bit of body work that is needing doing. Thankfully...

Hi Guys, may I ask, is it possible to “Bleed the Brakes “of a 1998 LC100 4.2D VX RHD Landcruiser with the TechStream program, in the same way TechStream can bleed the brake system in later Landcruisers. Thank you. Hi Guys, may I ask, is it possible to “Bleed the Brakes “of a 1998 LC100 4.2D VX...

Hi 2001LC. Yes my Big mistake not mentioning the non working ABS. I yet again apologise. I’ve just got so used to using my vehicle without it. I have drove for a many years now without it, in which time I have replaced at least two brake callipers and did have the loud warning squeal from...

Once again, Many Thanks my friend. I am confident all process is being followed 100% correctly. I am concerned there is a micro burst or leak somewhere in the system that I have not yet detected. Although I got the Rear Right and Left callipers to bleed I was not happy with how slowly the fluid...

Unfortunately I am beginning to think I have some as yet undetected problem. I am following your directions diligently. The pedal is pressed in and out approx 5-6 times. Then pedal pressed, While pedal pressed I open brake bleeder for no more than a second and close bleeder while pedal is...

Hi 2001LC. Unfortunately I’m having a load of trouble. Rear brakes all good. All old fluid removed and new fluid in. However I just can’t get the front brakes to bleed. Going from froth to nothing to fluid to froth. There is air pressure coming out at times when you open bleed nipples I...

I meant to say, my accumulator seems to be working perfectly. However given my comments re very slow discharge bleed rate on rear bleed nipples I took a few timings. The accumulator takes about 6 seconds to recharge itself during the open bleed nipple at rear wheel. It takes 23 seconds...

Thank you my friend. I checked the bleed nipple and it is perfect. It had a very good rubber cover on it as well. The accumulator took exactly 40 seconds to recharge after 40 pedal discharge. I have battery charger on as well. I’m just surprised how slow the brake fluid is coming out. I...