Recent content by trig8r

Can anyone post detailed photos of solid linkage for Aisin carb? I have two different brackets and still can't figure out how to get from the pedal to the carb.

I am in the same boat only I have been at it a lot longer and have probably thrown a lot more money at it. I am keeping at it, hoping that it is worth it in the end.

After-market window regulators for doors without vent window. Got them installed, then realized they were only for non-vent window doors. $50 +shipping. These are $125 each on some parts sites

Anyone have photos of how PS pump mounts on left side of the engine? I bought new brackets to swap the alternator and PS pump but can't figure out how it mounts without getting in the way of the air filter.

Currently rebuilding 81 2F. The Weber carb was definitely running rich and pistons/ valves were pretty scorched. I know I can restrict the flow but I am considering going back to OEM carb. Would like to hear thoughts and experiences on both options.

Thank you!

Definitely not dressed. Cam was cleaned up.

Rebuilding 81 2F engine and I am finding that the rocker support assembly doesn't want to fit down over the studs and I can't figure out why. I don't want to force it and damage the threads. Any ideas? Also, the machine shop did not label the lifters. Am I taking a big risk just tossing them in...

Not sure if anyone is still following this thread. I tried the wiring suggested above by @Coolerman and the regulator started smoking as soon as the key was set to ON. Any thoughts?