Seems feasible. Might be helpful to see the wiring diagram for the 343 to see how that tranny has the button wired. Seems like the 442 would be a similar setup? I feel the button is a must have in low range on the trail. When you figure it out I'll be sure to let my buddy know, his 94...
Rodney flush is awesome. I put about 16 quarts through and it was coming through the clear tube nice and clean by the end. Filling through the dip stick tube is definitely the bottle neck of the process, watch how quickly you pour or you will end up over flowing the fill tube and making a mess...
I find the 2nd start switch extremely useful in low range on the trail. I basically have it on the entire time when in low range. It makes driving between obstacles much smoother as you can simply downshift to first manually when getting into a crawling situation. Then on the flats you just...
I certainly agree that some clearance is needed there too account for tcase movement when torque is applied. How much of a gap would you say is present in your setup between skid and tcase by the drain plug? I imagine if I take the support foot off I could use a floor jack to bend the skid...
Wow, yours is much closer. So just to confirm, yours is the newer design with the metal guard plate welded around the transmission mount studs? I will double check my tranny mount height. I did replace the tranny mount a little while back (factory toyota part of course). I did not notice any...
Just purchased new design ipor skid. Got it installed and noticed that there is 1.25 inches between bottom of tcase and the top of the tcase skid tongue. Is any body else noticing this? I have a 97 lx but I wouldn't think this would be a factor. I have a buddy with a 94 and the older style...
Well Dang, so close to a solution and yet so far away. I wish I had bought the cruiser several years ago when these units were in production. Any idea as to the possibility of me going to visit the place you were having the parts for the "clock holder" produced at? Maybe they could at least...
How is the heat on the passenger floor board (front and back) compared to the stock cats? Have you had to install any thermal insulation on the floor to keep from melting the carpet?
bump bump
How's your exhaust system doing these days. Is the CEL still pretty rare? Any issues with the heat wrap around the over the frame pipe, rust, corrosion, etc? I am really edging to get that same spun cat and run the pipe over the frame.
Not trying to wake the dead but is there any chance we could get some refresher pics of your adjustable caster mod. Seems as though the original pics have been eaten by the incanet gremlins.
Thanks