Recent content by Tmparker05

Interesting, mine can out great for me. First time attempting this type of project and applied all the internet tips I could find to preserve and bring back the original foam. I also added about 3/4” extra padding all around for a little extra plush and to be sure alll the material was full. I...

Why do you need to fully recline the seat? I just finished replacing mine and I had to remove the entire seat.

For sure the zip tie is likely the route until I can find source it. Thanks for the help though.

Hey thanks I have these The best I can do at the moment is this I’m away for a few days. It’s in the back of the motor were the harness for the starter connects to the main harness that then connects to the fuel injectors, coil packs and everything else

Thanks Kamran, I did as suggested and found this 90980-11161. The closest I’ve found ends in 62 but it’s the wrong fit. It’s the black conector circled in the photo that connects the starter harness and main harness. However that part number doesn’t give me the correct clip. I’ve reached out to...

Does anyone know what part number or connector this is called? Mine is broken and I cannot seem to find any info on it

pulled my motor last week lots to do ahead

Following - I also ordered a new rack recently and made the same assumption. Same leak on the box as well

I was in Texas and they had a similar setup that also blew mine off. I think it was Blue Wave, I called to make a claim and they basically told me to read the sign. They weren’t responsible because you enter at your own risk.

This

Hello I’m in the process of this and the same thing happened with me. The Tc came with the motor. Seems the the mushroom style head had some corrosion that was causing resistance. What was the end result did you have any tranny issues after install. I just pulled the motor last night but want...

Try these guys once you find your paint code. I used them and they offer paint chip kits and more. The color match in my opinion was great. A little darker but I figured that’s due to fresh vs 28 years of oxidation. https://repaintsupply.com

Thanks for the input I've read through all the threads and decided it’s a pretty even split of opinion. I’ve also used them for enough parts over the years and not had an issue so I went for it. Craig has been fantastic to deal with so far. I’ll report back in a few weeks when I get it all...

Hello there, im in need of some of the forum members experience with the Vendor listed in the subject line. They are based in New Hampshire which is conveniently closer to me than any of the other well known shops in the northeast. Im in conversation with them about pulling a motor from one...

Great video I’d imagine there are a lot of folks here in a similar scenario. I know I am and I’m about to pull my engine and start the tear down. It has 360k miles and I blew a head gasket. Considering swapping for a fully refurbished motor.