Recent content by TLCMAN48

Front shaft free. 2 wheel high for tc. Can't find neutral. When clutch is in the world is good I had to remove tc shifter some time ago it was frozen. That seems ok. It did shift prior to me removing stick but will not find neutral Help. I can shoot inside of top gear box if that is good Thanks

I had to remove the floor shift two years ago for a complete rebuild on a 72 3 speed I'm now ready to put it all back together put the shifter back in and now can't really feel it shifting properly what am I doing wrong .is there a trick. This is a new one on me Thanks

Will this dist work on 73 F motor my dist vacuume has a hole in it. It has all new parts but Thanks

I have a project 73 with all the parts. Needs some cosmetic stuff. Live on cape cod. It is on Craig’s list Good luck

Can you give me the links on this.....im looking to do the same, thanks

73 original 2 f has not been started in 15 yrs. What can be removed from carb without effecting running,evaporated. Emission control device etc. is the line to fuel pump the only one required?, Gas tank gone.......any other advice would be helpful, Thanks.

Mrmomo had it. Shoe welded to drum. Once I was able to get it off all went well. Thanks to all who assisted.

Was able to get them loose by utilizing break adjusters. One however seems to be loose but will not fully rotate. It hits what sounds like metal. Other than removing the locking hub any suggestions?

They are drums. What about trying to adjust the brakes looser. Any thoughts?

It is a 74 both left and right the same rears not an issue.

Recently purchased old fj with warn locking hubs. Need to trailer it but front wheels feel welded in place. Checked PTO and TC both in neutral. What is the best way to get these puppies loose so I can move the vehicle? TLCMAN48 I did not see this in faq's. Thanks I am a newbie