Hey Dudes,
If you have a set of aftermarket upper control arms with uniball joints and the joints are due for a replacement, this video will show you how to swap them out. We feature two tools in the video. One comes from Total Chaos which is a specific tool made to replace uniball joints. The...
So you're saying that oil intrusion into the spark tube well is due to the the connection of the spark plug tube with the head and not a faiied spark plug tube gasket? That is interesting and I find it difficult to believe. I thought the spark plug tubes are installed into the head with a...
Oil leaks can be fixed. If you clog up oil passageways and starve parts of your engine of lubrication, now you're talking an engine replacement. These engines are very good. If you're still using 0w-20 oil, I suggest switching to a 5w-30. From what I understand, the oil spec for this engine...
That would be a horrible decision on your part. Those oil seal additives can wreak havoc on an engine. If you want to hasten the demise of your engine, go for it, but you've been warned.
Remove all 8 coil packs. If any ot them have oil on them, that means the spark plug tube seal has gotten tired and isn't able to keep engine oil from getting past it. People usually discover this when they are replacing spark plugs as preventative maintenance.
For this video, the valve cover gaskets weren't leaking but several of the spark tube seals were. When the spark tube seals allow engine oil to get past, the spark plug wells fill up with engine oil. Once enough engine oil gets into the spark plug well, it could foul out the coil pack and...
Hey Y'all,
If you have a 2nd Gen Tundra or 2nd Gen Sequoia and you have the 5.7L 3UR-FE engine, we have a 2-Part video series that will help you perform a Valve Cover Gasket job, if you find that you either have a leak at one or both of the valve cover gaskets or at one of the spark plug tube...
Hey Y'all,
If you're due for a Valve Cover Gasket Job, we have a 2-Part video series that will help you get the job done. I have to say, it's a bit of a pain in the butt to do a valve cover gasket job on this engine, but hopefully with our video series, you'll have a much easier time getting...
Hey Dudes,
If you have a 1st Gen Sequoia and you're faced with a Rear Axle Bearing & Seal Replacement job, I have a 2-part video series that can help you get it done right.
Here's Part 1. I hope you Dudes enjoy it. Happy Wrenching!