Recent content by th3l0cust

With a couple bikes on the rack, you can push the rack fully closed but the handle has enough friction that it wont fully engage unless you push it pretty firmly. Adding the pin is really a reminder to ensure its closed and latched.

Literally did exactly that after having my rack swing open with bikes on 2x on the freeway. no worries any more.

Installed my Dissent roof rack.

Relocated because I was rubbing pretty bad when I stuffed the front tire. Was a 1 banana job, remove 3 10mm bolts and the old one just drops out. Then you move the pumps to the new tank and extend the lines and wiring harness. Could you reshape the stock one? Absolutely, but this is cleaner and...

Yeah I think he had a family emergency, should be back to shipping stuff now. I just got mine yesterday.

Sure what are you interested in? I’ve got more install pics.

Installed the @plaidwagon washer fluid tank. no more rubbing on full compression and no more plastic bit sticking down from the Dissent bumper.

not sure where you are getting your info from, CA probably has the MOST modified vehicles in the US.

here is how i did a 5# under the jerry can holder, its been working fantastic for 2 years now.

been running a 1up on a dissent swing out for 3 years now with zero issues. you won't notice the bikes being off center.

weathertech

No more Saggy seatbacks! thanks to @plaidwagon

pulled the wires and cleaned all battery terminals, replaced the really roasted negative terminal with new OEM. then wire brushed / wheeled the ground locations and bolts on the block, starter and engine bay.

had this issue and same, it was a ground issue. pulled and cleaned all grounds in the engine bay and its never come back.

ha ha! this story put the puzzle together, the bike world and land cruiser world collide ( they seem to be pretty close together already anyways)