Recent content by TexFJ

These guys did it to the side of the rocker panel. How can you reinforce this?

Update on Hopper: new wheels and tires getting tested by my daughter:

Won't go back to Tireman. they over torque the bolts with their pneumatic tools. Asked them to rotate my FJ62 tires and they broke off one of the bolts and shrugged... They also don't care about scratching the chrome wheels with their long sockets.

Are you keeping the front side of the space with the amp open? if you're closing it up, consider a fan to get the heat out of there.

easy fix for the wobbly shifter.

wow... 150A?! part number? is it a drop in or did you need to customize a bracket?

Did you ever check the voltage with your fridge running? I'm switching back to non-AGM for the SAS trip as I installed the Eco Flow Alternator charger without replacing the alternator. Perhaps when I spend money on my Alternator then I'll be able to spend money on an Odyssey. The 80A...

Good week to be a Cruiser dad... brakes and shock absorbers being replaced on their respective rides. I had to take over banging on the bushings though.... trying to see if the springs can be saved... only 140k miles so perhaps they can. But the compressor cannot be saved hence ...

the floor is cleaned up, now comes the carpet... OC Carpets provides great molds. some are spot on and some are off... it's always nerve racking to make that shifter hole cut. patience and a heat knife are key..... I've been looking for some high pressure steamers to help, perhaps will help...

Back at it... fixing those darn rust holes. biggest thing I've learned is that you should assume 18 ga. (even though I'm suing 16 ga.) when setting your welder... burn throughs suck...

Here is a potential solution.

Correct, connectors are just connectors, they don't guarantee what you have in the system. it's all about the manifold gauge compatibility. it's what you connect to the other side of the manifold Gauge is what counts. R12 or R134. Only the Low side was put on as the High side 3/8 -24 UNF...

33"s seem to clear quite easily. thanks @CenTXFJ60

I can lend you a rear third member, I can drop it off at @aljollano and you can have him put it in.