that is correct. No power out. I was thinking about upgrading to the power in/out motor and I know then I would need to add a solenoid to accomplish that. I just haven't seen one of my switches anywhere on this site. That the reason for the ask.
The sad part about this is I have so much time and...
Question for the masses - I just finished rebuilding this old M8000 and it had what appears to be a type of push/pull cable on/off switch. I figured that if that was good back in the day, why not today? Anybody still run this? Should I go to a solenoid?
They are rough country and boy are they rough. I have wondered about the shackles myself. They are almost in the same position as they are shown here. Anything I can do to fix this?
Thank you for that! I used 1/8" flatbar and bent it to match the contour. Had to weld a couple of tabs for the front but the rear I just bolted to the rear cross member - note: drop the bolts in from the top on the rear cross member. Once the tank is in, you cannot access the nuts for removal...
Here she is all installed. 1995 Chevy S10 Blazer tank. 20 gallons. Rockauto had the best deal. Make sure you match the fuel pump for either carb or EFI. You don't want to run 60lbs of fuel pressure on a 6lb carb.
I used a new 28" tilt steering similar to flaming river or ididit. Had a 32" that was given to me and it was way too long. Since I have a 71, the key is on the dash. Went together pretty well. Used a Borgeson Universal Steering Universal Joint Steel 1" DD 11/16" 36-Spline to get into the Mini...
OK..I thought I was the only one with this problem. I too used the monte carlo calipers and brackets. I went a step further and used a hydroboost with a GM master and proportioning valve on the rear. Pedal is soooo hard its like the hydroboost isn't helping at all.
Just had to disassemble my 1F valve train and had the same issue. It was easier to remove each half and then remove the clips, spring and rockers from the center rather than the outer ends. If the trains are similar....
The center joint slides to the rear half once the screw is loosened. Oh, and...
Having done the rear fuel tank myself and moving the filler to the rear panel, David1947's fuel filler location is a much better than mine due to the filler hose routing. If I had it to do over.......
I built a poor boy rotisserie using 3/4" plywood, 2x6's. I'm a one man show so there was no choice for me.....and I don't like spending money on silly things I'm only going to use once.
Don't want to hijack Xpnsv72fj's thread here but the tank is from a 1994 S10 Blazer. 20 gal with TBI fuel pump (about 9-13 psi for carb) If you are running modern fuel injection, you can use the MFI fuel pump that has 60-66 psi. Don't put the MFI system on a carb or she'll blow.
Going to have to get back to you one the specifics. If i remember correctly, it is a 95 blazer. Rockauto had the best deal on tank and pump. I seem to think its a 18 or 20 gal. Again, i would need to look it up.
I chose this one because it it fit with no alteration except the tank straps. Few...