Recent content by SR5BFG

Flex Function in Campbell are toyota guys.

The Autozone branded semi metallic pads are not adequate for a heavy landcruiser. I had them on mine and they were terrible. They work fine on my daily 2005 4runner though. I'm running Hawk super dutys in front and LTS in the rear (seems like they don't have a super duty for the rear when I was...

I bet you have some high spots or burr's on your hubs. I had the same issue. Took a grinder to the high spots. The spacers now fit flush.

Thanks for the part number list!

Answering my own question...found the part numbers: 47777-60020 shield 90105-06282 bolts

Does anyone have the part number for these (mounting bolts would be helpful too)? My LC doesn't have them and looking to add them.

Thanks! I like the under drawer table you have created. I also did one but nothing as nice as yours.

Do you have any suggestions for one trying to replace the rear harness? I tried following the harness with my hand, but lost it over the left frame/ cross member junction. Is this where the connectors are located? thanks, -SR5BFG

I had the same problem. My hub had some high spots from the casting. I ground down the high spots, and now my spacers fit perfectly.

Tried messaging you but you're PM box is full.