They came out and went back in without any issues. My distributor went right back in and spins like it did before I took it out. You could probably even insert the distributor while you reinstall the bolts to keep things in line.
You'll need to drop the oil pan though. Since there are no...
I cut my previously flared brake hose threads down to about the length of your OEM hose pictured. It bottoms out on the washer surface long before it reaches the bottom of the union. The copper washer provides the seal.
OK awesome. Let me reach out to the mud vendor and see what I can do about possibly swapping these hoses for the right ones. If not, what's the best way to order these hoses from you?
Ah, that makes sense then. Mine is a 9/69 build but I replaced the 9mm plumbing when installing a tandem master and the fittings are from a 71-72 truck. Not planning on heavy off-roading in this. Just light excursions to some remote fishing holes :).
I just ordered some stainless steel brake...
Pretty sure these are intended for a flare seal since they have a flared end. Is there a land cruiser that uses this setup? These were sold as FJ40 hoses.
I have a 2" spring lift plus taller shackles which is why I bought these longer hoses. That extra length seems excessive though when I put...
I picked up a set of hoses to fit these 10mm fittings but the male threaded ends bottom out before the shoulder makes contact with the T unions. Curious if anyone has an idea to salvage this before I order something else. It looks to me like these just won't work. The copper washer is not on in...
With the new dual brake master and a PO hole already drilled above the ignition switch, I decided to add a little functionality upgrade. The box of gadgets I got had a two-wire red indicator light with it. I slightly enlarged the hole in the dash with a stepped drill bit and ordered this etched...
I polished up all the brass connections and used an acetone soaked rag to scrub off any oil or grease caked on the wires. A couple of crusty connectors were replaced with new ones or from donors in the wire stash box I got. Front harness is complete and installed! Not connecting peripherals yet...
I scored a box of OEM wire and gadgets that look to have come from a 71-72 truck. I have some sections of wire that are missing or cut/ripped too short at the connector and will use this to fix that up.
I lengthened the water and oil sensor, reverse switch and coil wires back to original spec...
Ah. I'd actually considered just ordering a new housing since they're so cheap. I think I'll give that a try.
Hard to say if mine is thicker or not. The PO had removed the gasket and sealed shut with FIPG and no filter and then added a cheap inline filter in the hose.