Recent content by shadow247

  1. S

    I’m ok. Trucks not.

    All depends on your endorsement. If you have no endorsement, you get usually 500 bucks in "aftermarket coverage". You'll have to double check with your specific carrier, but as long as you have them value the vehicle with stock parts, then you are perfectly ok to remove any and all customized...
  2. S

    I’m ok. Trucks not.

    It should be covered. I'm a claims appraiser for one of the big 5. I write claims every day for ATV's/Motorcycles and Trucks that have been damaged off road. As long as you aren't in a sanctioned event or practice, you are covered.
  3. S

    For Sale 2007 Lexus GX470

    Location? PICS?
  4. S

    Please help

    check www.t4r.org - Go to the 2nd gen section. LOADS of information there on lift setups. I'm positive the answer you seek can be found there with a few quick searches.
  5. S

    Rebuilt Engine Good or Bad?

    I agree. I worked at a GM Dealer 2 years, and another Ford Dealer for 2 as well. I can tell you that exactly 0 engines were rebuilt at the dealer. I don't know how Toyota does it, but I would think a new shortblock would be a much better option. That knocking could be anything as simple...
  6. S

    SOLD 02 LX 470 in Louisville KY

    Skid Plates? Driver Seat Bottom only?
  7. S

    Repair or will insurance total this?

    Looks like 6-8k of damages minimum. Could be close. If you are in California, the insurance has the option to go up to 100% of the Actual Cash value. CA has no total loss requirements, so you can actually fight hard to keep it from totalling. PM me once you get more details and I can help...
  8. S

    Battery Charging Light flicker/ Alternator issues?

    Probably the brushes are failing. New brushes are dirt cheap compared to a new alternator. The OEM Denso rebuild is the only one reliably know to last. My first Ultima from Oreilly's fail in a year, and I'm about to hit 2 years on the warrantied replacement. If this one fails, I'll be biting...
  9. S

    Repainting Damaged Quarter Panel; Input Needed!!

    Here's my .02 from 20 years in the body shop. Unbolt the Door handles, and remove the window moldings, this will make it easy to mask off, you can also unbolt the side glass pretty easily, you're already almost there with all you've removed from the interior. You are better off not having any...
  10. S

    “Floating” feeling

    Yeah I made the mistake of letting the Sears we contract with replace the rear brake shoes and drums. I took it to get inspected the next day, and it FAILED because the parking brake literally did NOTHING! When I took it back the manager looked me dead in the eye and said "All you said to do...
  11. S

    Timing belt idler bolt frozen

    I was gonna suggest a little heat from a micro torch. Heat and cool the bolt a few times in between spraying with PB Blaster. I've also had good luck with the FreezeOff products. A 6 point socket is also crucial for bolts that are giving you trouble, as you'll be more bite on the bolt head...
  12. S

    Parting Out TX, Parting Out 2000 Land Cruiser, Gray/Tan

    Rt Fender with Cladding Skid Plates?
  13. S

    Fancy/classy wood veneer removal?

    Hair drier and a plastic scraper. Just be careful, because the plastic can still scratch. You will only want to use the scraper to lift up the edge and hopefully peel it off in 1 shot. Goo Gone will remove all the glue residue left behind. I recommend doing this on a really hot day after...
  14. S

    OEM shocks bottoming out

    Get Airbags, this way you will still have a nice ride when unloaded. Heavy duty springs will put the rear end WAY up in the air when unloaded. The Airlift kit is the cheapest way to go, and it's adjustable, so you can balance you load from side to side as well. 85 bucks with Prime shipping...
  15. S

    Window motor issue?

    FWIW, my passenger motor appeared to operate fine, and the regulator appeared to move freely, but once it was all bolted together, the years of wear on the rollers creates enough slack to cause it to bind up a bit and roll slow. I replaced it with an aftermarket unit about 3 years ago and it's...
Back
Top Bottom