Got new plug bleeders for my front calipers and rear drums from my local Toyota dealer. I have a May 78 production year FJ40.
According to the dealer the front ones for the disc brake calipers are the shorter set P/N 47547-12010. as acquired from the PO my front calipers have the longer plug...
a few final pics of the front. i like the the aluminum pulley with the bolt on key vs the spindle style on my old setup. gives it a whole new look.
a few comments as to why i went this route. my 78 FJ40 is desmogged and so i couldn't move the man-a-fre bracket forward on the head to run the...
I removed the old bracket from the head and re torqued the head bolts down. Supported the engine on the driver side to remove the stock motor mount bolts. The kit from Valley was great as it includes longer bolts for the motor mount so the whole project was pretty turn key. I decided to mount...
Writing an update to this thread as i recently installed the Bill Dorry PS pump bracket as supplied by @orangefj45 at Valley Hybrids. PO had already done the Saginaw box and pump conversion using the Man-a-fre setup circa 2009. While the PS worked pretty good, i was experiencing some leakage...
Looking for an intake air horn for my 78 FJ40. I plan to blast and powder coat so any condition is fine so long as it's not overly rusted and pitted out.
Was missing when i bought it, i believe it looks like this...
bummer, will let you know if i see any out there. my manifolds are a different pattern and from what i can tell pretty much unobtanium for the heat shields
Not sure if you found what you are looking for but this post has both insulators...
https://forum.ih8mud.com/threads/boise-id-9-75-my-76-2f-misc-parts.1374607/#post-16190479
Reposting my search in the parts classified i accidentally posted in the Vehicle-Trailer section...
Looking for both exhaust heat shields for my 78 FJ40 that were missing when i bought it. I plan to sandblast and powdercoat so not too concerned with finish but prefer steel that is solid and...
Looking for both exhaust heat shields for my 78 FJ40 that were missing when i bought it. I plan to sandblast and powdercoat so not too concerned with finish but prefer steel that is solid and not heavily rusted that can withstand a refinish.
Larger heat shield:
Smaller heat shield:
Sweet! You beat me to it. Got distracted with my wiring harness install and didn’t get a chance to call them.
Did it come with the firewall grommet attached in the middle and if so assuming it fit the hole in the firewall correctly?
How much did they charge you for it out of curiosity?
Thanks woytovich, your thread was of tremendous value and inspiration to me when I started my harness rewire project! It allowed me to tackle what can be an overwhelming task for folks who don’t have lots of auto wiring knowledge with relative ease.
But I found once you unlock the magic of...
Resurfacing an old thread on the topic of 1978 FJ40 wiring harness work.
I recently went through my main and rear wire harnesses for my May 1978 production FJ40. Using the OPs chart, several other posts, the pdf wire diagram and various other resources as a guide and updating based on my...