Recent content by rlynch356

Backorders should be shipped the week of Aug 25th.. and i will have stock on hand. Also started carrying some other brands, such as Hest, Ignik, Goose gear, Victron Energy, Vision X, and Proeagle jacks and some other brands coming soon.. I am offering 10% off on partner brands for August...

Do you have any pictures of the rear anti roll bar mounts and end links? looking at ideas....

oh yeah, did those too at the same time...

164K - only thing as been a seeping water pump, replaced water pump..

I have 2 available for Shipment Monday the 21st.. 20 more are in production for the next batch.

Production update: I will be shipping current back orders on Monday the 21st - I am starting production on the next larger batch in parallel, since I only have a few more in this batch. I plan on doing larger batches from here on out.

Possibly a tundra swap front end but i would imagine that all the description means is, cutting a lot of the fenders out for the flares and body mount chop/mods, and a diff ratio swap to support the tire size. And -52mm is apx 4" further out than say a Rock Warrior wheel

Found this interesting... AT35 CORE SPECIFICATION: Extensive Arctic Trucks re-engineering to frame, inner arches, body, bodywork and axle Widened 10-piece Arctic Trucks fender flare package, front and rear (body colour) Rugged 17×10 ET-52 Arctic Trucks alloys 35” (LT315/70 R17) BFGoodrich...

+18Et will be a problem with the up travel in the rear generally unless it is restricted via bump stops. My kit can clear the KDSS system in the front using the stock LCA's. Mods will still be needed for the rear of the front wheel clearance but that's pretty normal stuff, trim, push in the mud...

Based on this conversation with Geoff, I had the bracket destructively tested today (3 separate tests). Material: Aluminium 6061 Max Hold strength: 115Ft-lbs Failure: 120Ft-lbs - Threads pulled out.. The spec'd torque is 64Ft-lbs (all torque specs are factory Toyota, actually)

I'm sending back a Wolfbox G900, it keeps freaking out, the reverse camera setting is erratic (hooked up or not), basically its not OEM quality.. It's the 2nd one as well, since the 1st lasted 2 days before dying.. so the quality is suspect at best. Are there any OEM quality replacement...

sounds good - I'll try and make it I should be back by then - been a crazy couple of months with travel

This batch is sold out, ETA for next batch is July. I will be taking back orders and shipping as son as I get them.

ditto..

I have 2 more kits left in this batch, the next batch prices will have to go up unfortunately, but seeing where I can minimize the impact. I will go on back order once these sell out, hopefully will be July when the next batch is ready but there is a lot of Labor in each kit. Just an FYI...