Recent content by Phaeton5

Located near Chatfield State Park Red Line front axle relocation brackets, brand new never used $35 LCP front swaybar disconnect, used $75 Delta 1" front spring spacer, used $80 Slee 4" lift medium front springs, used $125 Slee 4" lift caster correction plates, used $90 OME rear shocks, used $free

@crikeymike, what do you recommend to achieve the necessary bump stop extension for 6" lifts since this kit only comes with 2" bump stop extensions and I don't see the "extended length bump stops" on your website? I can pair the 1" frame extension with a 2" I already have, but there doesn't...

Do you have any pictures of your mounting bracket? Did you repurpose the radiator overflow mount or make a new one too?

Thanks! Not sure why the Partsouq diagrams don't show those. Where are you looking?

Can anyone help identify part numbers for the four bolts attaching the CDL to the transfer case? Three are short and one is longer, so maybe they're just two part numbers?

Do you still have the heat shield for the exhaust pipe that routes over the frame? 58153-60030

Still available?

Do you have Y down pipe? I'm interested in the pipe from the flanges interfacing with the manifold down through the "y". I don't need the cats.

Have you gotten any 1fz Y pipes yet? Manifold back without cats.

Thanks for the pics. I'll pass though. It's a little rustier than I'm looking for in the area I need. I appreciate it!

Do you have down pipe for a 1FE-FZ? I'm interested in the pipe from the flanges interfacing with the manifold down through the "y". I don't need the cats.

Do you have the exhaust down pipe? I'm interested in the pipe from the flanges interfacing with the manifold down through the "y". I don't need the cats.

Do you have down pipe for a 1FE-FZ? I'm interested in the pipe from the flanges interfacing with the manifold down through the "y". I don't need the cats.

Do you have the down pipe? I'm interested in the pipe from the flanges interfacing with the manifold flanges down through the "y". I don't need the cats.

Do you have the down pipe? I'm interested in the pipe from the flanges interfacing with the manifold flanges down through the "y". I don't need the cats.