Recent content by Ofcrtj

  1. Ofcrtj

    SOLD Atlanta: 80 Series, 1997, 3X Locked

    Im going to update the post shortly with chassis pics, vin and motor pics
  2. Ofcrtj

    SOLD Atlanta: 80 Series, 1997, 3X Locked

    It's time to sell my 80. I recently transferred jobs losing my company truck leaving the 80 as my only vehicle. Unfortunately, my commute is too much for this to be my daily driver so it's time to let her go. It's a triple-locked 40th-anniversary edition there is plenty of miles on it 397,XXX...
  3. Ofcrtj

    CDL Actuator Fun

    How did you end up solving this? Dealing with the same issue right now.
  4. Ofcrtj

    94 Fzj80 Oil Leak Diagnosis

    Next up for me is the PCV. I’m going to get the wits end kit and do the whole set up.
  5. Ofcrtj

    94 Fzj80 Oil Leak Diagnosis

    Currently chasing the leak dragon as well. I have recently replaced oil pump seal, front main seal, and distributor O-Ring. I have plans to check way down this list, any you see as a higher priority? I am still getting some leakage if I run it for a long time. She has 385k so it’s no spring chicken.
  6. Ofcrtj

    SOLD Atlanta: crank holder tool

    Pm sent
  7. Ofcrtj

    Front Axle Rebuild - For FAQ

    So I answered my own question today and thought I would post my findings for anyone else that may be curious. I discovered today that the last time I did this job, several years ago. I put the wheel seal in backwards and is what caused that strange wear and premature failure of the seal...
  8. Ofcrtj

    Front Axle Rebuild - For FAQ

    Thanks for clipping that out of the FSM for me. I have a race press now and didn't use one before, I defifinetly did not pack the hub with grease between the two bearings. I also I think my preload was wrong too, I was getting some 12 and 6 O'clock movements once I got the tires off the ground...
  9. Ofcrtj

    Front Axle Rebuild - For FAQ

    Yea I realized what you were talking about after I posted it. But I have replacement inner hub seals too.
  10. Ofcrtj

    Front Axle Rebuild - For FAQ

    Thanks for the tip
  11. Ofcrtj

    Front Axle Rebuild - For FAQ

    Question and Confessions Confession: When I bought my 1997 80 series in 2014 I did the axle rebuild myself. It was the first thing I had ever done on the truck, and knowing it would be a project vehicle wanted to do the work myself. It was a very rushed job and I’m sure I cut some corners...
  12. Ofcrtj

    SOLD Atlanta: crank holder tool

    Otramm crank holder tool for 1FZ-FE. Used once. $60 local pickup. $70 shipped USPS flat rate.
Back
Top Bottom