Recent content by OCGX

Amazon.com: Tongkat Ruiting Store 1-20 Sets 6 Pins Automotive Connector 6189-0143/90980-10939 6188-0187(Male Set,1 Set) : Electronics - https://www.amazon.com/dp/B0DJVDD2HW?lv=shuf&channelId=500&plpRedirect=mhFallback&th=1 If you have removed the ABS and have the relay connector there, this...

Rock would be the least allowable wheel slippage.

I rarely use my lockers. I have had only one situation where the lockers worked over the MTS. That was coming out of a creek up steep granite stairsteps. The times I've gotten stuck and had to winch, the lockers didn't make the difference. That said, I was already doing the regear, so it...

I was just in Yosemite for 5 days for Labor Day. Must have just missed you. We stayed at Crane Flats. Which campground did you stay at?

My 35's with Zero Offset wheels rubbed the UCA, you can see it in my pic above.

Here is a side photo. The front is trimmed maybe an inch or so, the rear is trimmed back as far as I could go. The installation was done by myself and a Toyota tech. The rubbing is going to depend on your setup. Wheel size/offset plus your spacers. Plus all vehicles are a little different...

Yes I’ve been running these since 2019. I currently run 35’s (305/70R18) zero offset wheels with 1.25 spacer. I have the DRT body mount, fender and bumper trimmed. His concern is likely they set your castor back and the tire will rub. With this UCA adjusted forward, I still get a little rub on...

Yes, can ship. I sent you a DM on Instagram. Thanks!

Yes

Ohana Rig Supply has a few products that may work well for the Scan Gauge 3. If I had one I would try ORS DESIGNED - GX460 SWITH PROS / SWITCH PANEL HANDHELD VENT BRACKET - https://ohanarigsupply.com/collections/gx460/products/ors-designed-gx460-swith-pros-switch-panel-vent-bracket

If anyone is near Irvine and wants this old diff fluid, let me know. I use 85-140 now on my Nitro gears. Edit: the fluid was sold.

For the Transfer Case Oil here is the supersession chain; 08885-81080 supersedes to 08885-01806 which now subs to 00279-DGOLF

He is only bleeding the accumulator. The FSM says to bleed the accumulator, then the front piston, then the rear piston, and repeat.

I worked at a shop that sold a lot of Icon. We had a local suspension guy we could remove the shocks and he could rebuild it in a few hours. The car wouldn't spend more than a day down on the rack. The stage 3 had the 2.0 shocks in the back. We would not waste time rebuilding these, we would...

Rebel Off Road is not far from Cruiser Tech and is big in the Jeep scene. Icon 4X4's shop is north of L.A. in Chatsworth. Never been but I've drooled over their builds. Also check out the SoCal LC Club sub forum CA- Southern California Land Cruisers -...