Recent content by MrAWD

If i understand him correctly, you use the pliers on the bottom of the worm gear, this grips the worm gear itself and then use the punch at the top to strike the shaft. The downward pressure coupled with the needle nose holding the worm gear sounds like it will work it loose. If I'm barking up...

Hello, I ordered the part on eBay and just received it, my question is two fold. Mainly… how do you get the worm gear off the old shaft? I’ve been pulling on it to no avail I’m afraid to break the gear. Second, does someone know which polarity is which? Not sure which side is positive and which...

Thanks guys upon looking at it it looks the motor has bit the dust, gave it some 12v power and nothing is coming out of it, Also think it may be stripped at the bottom as the worm gear looks to be turning freely from the shaft. I followed that link, it looks like that motor should work for my...

Thanks guys upon looking at it it looks the motor has bit the dust, gave it some 12v power and nothing is coming out of it, Also think it may be stripped at the bottom as the worm gear looks to be turning freely from the shaft. I followed that link, it looks like that motor should work for my...

Hey you guys, Does anyone have an updated link for these motors for a 97 80 Series. replacing the driver side door lock actuator today, Looking at some of these links I am unsure of the size or type I need. Thanks for the help in advance hoping to by 5 of em and replace all my motors

and here is my oopsie mistake i need to fix

Here is the "Doo Hickey" in question, what is this?

So it's been a while since I've torn open my 80 series and today I wanted to tackle the driver-side door lock not locking. So skinny is that the driver-side door lock will not lock with the buttons but can be locked with the key. So I tore open my driver-side door and pulled out the actuator. I...

Sweet Mary! you were right! I got one of the nozzles to start spraying after I stuck a drill bit up in there. I cant get the other one to spray but hey! It's at least a start! thank you!

sorry for the noob question, was digging back there didn't really see a check valve anywhere, any clue as to what this thing looks like? a diagram perhaps? Id like to add as i just remembered that a week or two ago i tried the rear washer (before i replaced the diverter and pump) and some...

Ah, Gotchya! if I'm honest, I don't know where this hose really travels through, in my head I just assumed the exterior cause that seemed logical but that makes sense that it would travel through the cabin. is there a guide to getting at the hose behind the quarter panel or am I just gonna have...

sent you a message

even though the leak is on the exterior?

the diverter is new, I did check it though, it is not leaking. the puddle seems to be a little further back than that

hmm that would make a lot of sense why it was zip tied, thanks for the reply :D Curious if someone has a diagram of the rear washer hose from the firewall so i can figure out where my leak is coming from?