Sorry about that. I'm looking into the email issues.
We are here and doing fine. Still short staffed but making product and shipping daily.
Everyone have a Happy Thanksgiving!
Everything is back in stock except black liner which will be a few more weeks.
Chemical shortages messed us up bad but we've secured a few new reliable suppliers and won't run into this again
Product will be back in stock in 3 weeks.
Raw material shortages have made a mess of everything.
Thanks to everyone for your patience and understanding.
Happy New Year!
Black Friday 2020 Deal is Live!
Now thru Sunday 11/29 @ Midnight - Get 15% off any Monstaliner order of $150 or greater.
Coupon Code: BF20-15
Standard shipping rates apply.
.
Place all orders @ www.shop.monstaliner.com
.
Conditions: Valid only for online orders placed at www.shop.monstaliner.com...
I've seen people use adhesive backed aluminum tape and coat over it after priming. Can't get the tape off afterwards but you could punch through it if needed in the future. Do you have easy access to the back sides of the holes?
Just need to be careful with strange tints that we have not tested. I mixed some Sherwin Williams tint once with tintable ML and it turned to gel/unusable in less than 15 minutes. SW makes all NAPA and Martin Senour labeled products so.... BE CAREFUL and read the Cautionary Note to do the test...
I see what you are saying.
First off the mix is not super critical and....
There are variances always in theoretical weight per gallon of all liquid formulas and then there are slight variances in filling cans.
We should probably over fill the catalyst cans by a little bit
PPG auto paint store only, toners must be PPG Shopline
see this PDF
http://www.monstaliner.com/documents/Tinting_ML_with_Auto_Paint_Tints.pdf
Double check your sq footage, 1 quart only covers 15 sq ft in the 2 recommended coats
he probably changed his name. I’m pretty sure he did a very slight overlap and he used some high-quality fine line tape either from 3M or J tape. If you take your time and work the tape down well into the texture you will minimize the amount of bleed that can happen. I’ve done one job myself...