Just wanted to say thanks for this thread. It was massively helpful. Did this job in about 4-5 hours. Never would have attempted it without all of these pointers. Used SuperPro bushings on my 99 LX and happy to report it made a huge difference. Used a threaded rod, washers and nuts to pull the...
Thank you so much for responding! I’m planning on working on the car again tomorrow. I think the set screw is in the correct place. I second guessed it because the top half of that spline is not seated in the ujoint. But as far as I can tell, it can’t. I’ll take a pic tomorrow. Do any of you all...
Finishing up this job now on my 99 LX470. This write up was SUPER helpful. Thank you! One question: my shaft looks a little different and I’m concerned that I’m not seeding it all the way into the U joint. Any tips and tricks? I can’t imagine how bad it would be if the shaft came out while...
That was my thought as well—just wanted to make sure! Thank you! I’m gonna do new hoses, a few rounds of flushing, synthetic fluid and at-205. That may help the leak enough to really plan a good time to replace the rack (maybe summer)
Curious to hear from people about this: are you guys saying you can rebuild your steering rack rather than replacing it? I’ve looked at a lot of threads and it seems like the consensus is to replace the rack. Mine starting leaking (really bad) from the driver’s side boot. I’m assuming I need to...
Thank you for the response guys! Appreciate you. I’ll keep you posted on my progress. I love great sound but feel like I’m somewhat limited here. Gonna do my best!
Thanks for all of the info on this thread. I’ll update when I do my install.
I have a 99 lx that used to have Nakamichi. Already switched head unit out for pioneer avh2550 nex. Sounds better but the speakers are rough and pretty sure the amp isn’t working correctly. Have intermittent sound out...
Awesome! Thank you so much! I didn’t see this, but it looks like I ended up doing the same thing! Whew!
I just capped off the unused red wire on the ARB end with a heat shrink butt connector (in case I ever add the running lights) and connected the other two wires directly to the stock Lexus...
This is an old thread, but can anyone give me insight as to how to wire the signals and running lights into the 03 ARB bumper for a 1999 Lx470? I’ve read about people using the corner marker lights, but the Lexus only has the turn signals in the stock bumper, right? So wiring from the corner...
Thank you for this! I just put in a new alternator, new alternator plug and have a new battery. Was still getting the intermittent battery light and surge and checked the Alt-S fuse. Tested good but was fairly stuck in there. Cleaned the fuse and the connections with electrical cleaner and it...