Recent content by Jjt35

  1. J

    Eibach pro-truck lift kit review?

    Sorry, I’m just seeing this. 285/70R17 with the front at 2.8”.
  2. J

    Eibach pro-truck lift kit review?

    I installed this lift a few weeks ago along with SPC UCAs on my DD 470. It’s great, I’d say a little stiffer than the normal stock setting but it helped with the brake dive and body roll immensely and is still very plush. Install wasn’t bad at all- it helps to have a second body if you’re doing...
  3. J

    Eibach pro-truck lift kit review?

    Yup that’s me
  4. J

    Eibach pro-truck lift kit review?

    Double post
  5. J

    Eibach pro-truck lift kit review?

    Tanner, sorry to post in this thread but your inbox is full. I ordered an Eibach pro kit for my GX 470 about 3 weeks ago and Poly Perfomance is telling me they’re not due to ship from you guys until some time in December. I wanted to 1- check if that’s true and 2- see if you had a rough estimate...
  6. J

    What can we do with this? Low mileage, supercharged fzj80 with a rusty frame.

    I’ll get in line, I’m on the east coast and would buy it for 4K if you pass it up. I don’t have it in me to do a frame swap but could use some of the parts for sure.
  7. J

    80 Series lean and spacers

    Thanks for the heads-up. I double checked just now and all the mounts are strong and rust free. The truck has seen trails between 1-3 times so in general is doesn’t have many issue associated with off road use except some paint damage.
  8. J

    80 Series lean and spacers

    That’s the weird part, the lift has only been on 3.5 years with 20k miles and almost no wheeling. The tire has only been mounted on the drivers side intermittently for 1 year and 6k miles. I’ll put new springs in if I have to but I’d rather not yet. I bought this truck to have forever but...
  9. J

    80 Series lean and spacers

    Hey all, I hate to make another thread so early but I have a question and despite hours of research here and elsewhere- I can’t find any insight to my specific question. Backstory: I bought this 80 from a member on the forum SOLD - 1997 LX450, Built w/37's, 5.29, ARB Front, 4x4Labs Rear, 183K...
  10. J

    Wrong grease in knuckles

    Hi all, I’ve spent hours searching but can’t find a definitive answer. I just bought my first 80 series and am going through it top to bottom. I checked the knuckles for grease and got some less than stellar news- what looks like general purpose red grease was used (leftover moly grease was used...
Back
Top Bottom