Recent content by jbstrong01

Same project. You can see my videos on my YT channel. I made a few slight mods on the bumpers and fender flares. Eventually that'll go and will do total paint resto. 1997 AZ only car, spotless, tripple locked. 291k on it and it runs flawlessly!

My motor's inside was in perfect condition. I cleaned it with electrical cleaner and greased it. My issue was actually the wiper "transmission" that snapped. When I replaced that they got better and a bit faster but they are nothing like my 04 GX470 or my 14 4runner. At some point I will get a...

When you pull the screws out, there may be some resistance bc the magnets inside are pretty strong. If one has come loose then that may be the cause. There is some resistance in there.

I'm gonna take your word on it, just picked up the last one here: Pardon Our Interruption... - https://www.ebay.com/itm/314747610085 I will post pics of the tear-down and install here and do the video on my YT channel. ☮️

Can you drop a link to the part? I found it on ebay here: 85110-60111 GENUINE OEM TOYOTA MOTOR ASSY, WINDSHIELD WIPER 8511060111 | eBay - https://www.ebay.com/itm/352647956673 but would like to know where you sourced it. Mine ticks and have a feeling when I pull it apart the wheel will be...

Mine just died. May pull it apart and rebuild but wanted to see if you replaced yours with this new unit yet. I see this part on ebay but have doubts. 85110-60111 GENUINE OEM TOYOTA MOTOR ASSY, WINDSHIELD WIPER 8511060111 | eBay - https://www.ebay.com/itm/352647956673

I need to make my first one! Going to try!

It WORKED!! Here is the process just like @Wrench said. (BTW: 1997 LC) Airbag reset: Go to DTC in engine bay. Small black box on pass side near firewall. Put one wire in Tc Put one wire in AB Put ignition to on. Touch Tc to ground .5 sec AB to ground .5sec Tc to ground .5 sec AB to ground .5...

From the FSM. Nothing about the stud torque but the nut is 71 Ft-LB

@Cruiserhiggs just send you an email and left a voicemail. I need some help ASAP! :)

Update! Just put the part in and it takes 30 min tops to get the sensor out, cleaned, new bushing on and put back in. The old bushing was brittle and shattered like the images above.

Love this! Solved my problem!

Part number for the o-ring/seal? I have the same leak.

Bummed I missed the last meet up. I have a question to the group. Best place to have my 97 front seals redone. I already know and use Desert Toy Shop and love them but I am struggling to spend the $2k anywhere to get the front done. I can do it myself but may not want to spend the time. I have...

Turns out my reservoir had a leak at the seam. Changed it out and viola! no more PSF drips anywhere! Good times!