Recent content by jayntguru

Wait - where did you find one for $125??

I used a brand new old style dryer.

It just works. Different pressure sensors, old style dryer, with new style refrigerant.

Here's what I had saved. -Jay

Great info. Thank you! I'll go ahead with the much easier fender splice. :) -Jay

I'm just confused on if the r12 sensor will work. I know the plug is the same but the pressures listed on the plug are different. Seems like a bad idea to use the R12 one. Although that seems to be what most people end up doing. -Jay

I'm in the middle of doing the relocate right now. Little confused on what to do about the pressure sensor. It looks like a lot of folks mentioned just reusing the r12 one, that seems to be what most have done as I see splices down the fender. Will that work? Or should I try harder to use the...

Question for anyone that has done this. I'm having trouble figuring out how much of the R12 lines I need. (Shipping is cost prohibitive to buy the whole set of lines from a donor vehicle.) It looks like I only need about 8" or so of the line with the sensor/switch, and I can't tell on the other...

@smittycrusher I'll text you, thanks. @pandathrust I didn't even know about him, I'll give that route a try. Thank you!

This is a stretch but I'll post it anyway. Looking for an aftermarket rear bumper for an 80. Small Stuff 80 windshield washer bottle 80 third row brackets including (especially) the little tie down thingies in the floor R12 AC lines from the evap and back past the battery

Name: Jay Land Cruiser - First one, 94 FZJ80 (recent Jeep convert) Instagram (not just LC content, FYI) - jayntguru Link Favorite Trail - none yet, I can only tell you my least favorite trail (!) I have no good wheeling pics - yet.

Here are our photos. Had a great time, thanks for putting this together. Let's do it again when it's warm outside. :) Google Photos Link.

Finally warmed up enough to paint my sliders I installed last week. Pretty happy with how they turned out. Need to re-paint the front bumper to match. Oh, and get a rear bumper. Also used the hydraulic ram to push the sheet metal around my tail light back out. Not perfect but it'll do for now.

Yeah that would be me - sorry Ben! It was great to meet my first fellow mudder, and only 3 miles away. Thank you @smittycrusher I also plan to be at the meetup. :)

I have it fixed temporarily. :) Later in the month I'll head to my cousin's shop and we'll finish bending it out properly. This was just a few minutes with a 2x4 and a mallet.