Recent content by GreatestDane

I only see 285s in 17in. Probably based on my zip code

Here is the link. Doesn’t look like it from tire rack.

60mph

What have I done to my 200 series… well hit another animal. This time was a medium size doe. At least I have an ARB bumper this time. Side note, anyone know where I can get these parts?

Got a new charcoal and evap canister. Cleared my code issues right up.

Do you guys just leave them plugged in all the time or just when you need it? Any harm in just having it plugged in?

Ahhh! I have not, that is perfect! Appreciate it!

Hey, I am looking to buy a OBD2 scanner for my vehicle since i started throwing the EVAP CEL (same has TeCKis300 posted about with the fix) likely in association with LRA system. When looking at which one to buy it's overwhelming. I usually use iOs. Any recommendations or what I should look...

20k. It sounds like it's coming from the rear. I went and washed the car to rule out some gravel or dirt and the squeaking is no virtually gone.

What would cause a squeak on BP-51s with side to side motion (jumping on the sliders) vs minimal front to back (jumping on the front or rear bumper)? Note: I have already done the rear strut fix and it doesn't sound like it's coming from that.

It seems like it doesn’t take much to cause a windshield washer fluid leaks with those headlight washers. When I hit an elk I got an ARB bumper after. My dad has one on his Tacoma and has hit 4 deer. No issues. Glad everyone was safe.

I am assuming you are responding to my post. So far so good other than a small area where the powder coat chipped off. I emailed them about any temp measure I can do to protect that area (no response). Only have had it on for 24 hours now but it is exactly as advertised. Assembly was easy...

Finally storing my spare in a better location

Hey, I just noticed this when I was peaking under the vehicle looking for the sound of a squeak (likely my BP-51s). Its the line from my LRA tank to the aux fuel pump. I have never really dealt with fuel lines, is this something I can just tighten and check on it later or is it more involved?

They identify a L/R but the parts fit either side