Recent content by GlennRauch

  1. GlennRauch

    Transfer case rebuild bearing kit.

    Where can I find a kit, other than on ebay from Australia. I live in arizona and prefer Shipping doesn't take 3 years. Also looking for a better deal.
  2. GlennRauch

    Fully locked 24 valve cummins landcruiser.

    I'll trade you my 92 FJ80 so you can build another.lol
  3. GlennRauch

    Repair broken intake hose?

    Gorilla glue epoxy and gorilla tape, did the job. If it's torn, tear it it half completely and just epoxy it back together. Gorilla epoxy it heat resistant and can take on pressure at 3200psi. Solved my stalls in reverse and better performance.
  4. GlennRauch

    I H8 Fires!

    Cool, thanks! I'll be checking it out this weekend. It looks like there's a couple sensors( two in the middle, under the intake manifold) that might have been roasted. Are those the throttle position sensors?
  5. GlennRauch

    I H8 Fires!

    I may have burnt some important wires.
  6. GlennRauch

    I H8 Fires!

    Code 41
  7. GlennRauch

    I H8 Fires!

    Water put the fire out. Now my Truck will stall in reverse sometimes, and gets better mpg.
  8. GlennRauch

    fireproofing under hood falling off

    It's a sound proofer. Caught my truck on fire when it fell on to the intake. Would advise you to securely fasten or throw away. Could use help on thread, I H8 Fire!
  9. GlennRauch

    fireproofing under hood falling off

    Caught mine on fire! So it's not for fire proofing. Any help with engine code 41, and the wires under the intake manifold. I H8 Fires!
  10. GlennRauch

    I H8 Fires!

    So the insulation from the hood fell on to the top of my engine causing the insulation to set fire. There are special wires under the intake manifold that got burned. The only code I have is 41 which is for the Throttle Position Sensor Circut. Anybody ever been under the intake manifold before...
  11. GlennRauch

    Parting Out 91 Land Cruiser - Parting out

    Still have the front windshield? How much? I also would like to know if you have the window switches as well. I need switches for right and left rear, and front passenger entire assembly with the plastic. Driver door limiter, lift assist for rear hatch and hood, turn signal switch, and antenna...
  12. GlennRauch

    91 FJ80 parting out

    I need window switches, rear tailgate latch, lift supports for hood and rear hatch as well, a turn signal switch, and possibly cruise control unit. I'm noticing a clunk sound from my transfer case/transmission area. Any experience with This noise? Don't know if it's bad or not. Let me know what...
  13. GlennRauch

    June ROTM - 6/20 Pyeatt Draw

    If I show up there, will I be able to find you all? I'm a little late getting up.
  14. GlennRauch

    June ROTM - 6/20 Pyeatt Draw

    I'm new to the forum. I have an 80 series locked on a 3.5in OME lift with 31s. How far from Phoenix sky harbor?
Back
Top Bottom