I will be at Lancaster Brewing Company (2323 Lincoln Hwy East) in Lancaster at 5pm. Their website shows 3 locations. I will be at the one on the North side of the strip-mall section of Rt 30. I'll be there at 5pm, meeting with TrapperHunt (or is it HunterTrapp?), a local club member.
I have 4...
Cleaning out basement. I have 3 soft tops for an FJ40. They are in great shape. Some have never been used. Windows are clear, no yellowing. They have been boxed and may have some "bends" that should smooth out on a hot summer day.
I have the frame parts for 3 tops. One of the tops has the...
I'll take some picks this Friday. I travel for a living, and will be outa town till then. $250 for the Snap top. $350 for the newer ones.
Stay tuned.....for the picks.
Soft tops for sale for FJ40.
I have 2 Besttop soft tops, 2 1-piece doors, and 2 2-piece doors without latch handles.
I also have a soft top with snaps along the bottom. This was before Besttop bought out Tiger Top. You have to install snaps along the rim of the tub so the bottom of the soft...
Right now I'm planning on being in CO for the SAS. I have to give away 2 shifts at work to free up enough time for the the 3 day drive each way plus the 4 day event. If I can't free up the time, I will be in.
I thought I responded (and registered) months ago, but I can't find myself in the thread.
77 FJ40, mostly stock
4J's prolly.
Coming from PA, so maybe some Dogfish or Victory. I have two craft places just 2 blocks from my house so maybe something special in a growler or three.
For any who read this, I solved the problem. Cruiser Outfitters told me that grease is built up in the drive shaft. I removed the grease nipple and squeezed quite a bit of grease out of the shaft as I compressed it enough to fit the axle properly.
Mischief Managed.
Hi all.
I'm in the thick of putting an OME spring kit on my FJ40 (77). I've got the rear springs on, but when I tried to sit the axle on the axle pins, my drive shaft bottoms out. I can't get the axle forward enough so the shoe sits on he pin. I measured my old springs (purchased from SOR...
I'm in the middle of putting an OME kit on my FJ40. I got springs on, but when I tried to put the axle on the spring pins, my drive shaft bottoms out well before the point where the pin meets the hole on the axle shoe. I measured my old springs (purchased from SOR near 20 years ago) and the...
Hi all.
I just joined (success on figuring out the Pay Pall thing). I've had this FJ40 for almost 20 years. I used to 4 wheel when I lived in CO. I haven't had her off pavement in a long time, maybe 10 years. She is ready ......all I need is time.
I could prolly do either. I'm in either way.
'77 FJ-40
XL
Pennsylvania
I'll bring beer, but there is allot of good stuff in Colorado.....plus, there's a distillery in Silverton (30 or so south of Ouray ??) that makes a great sipping rum. I'll be making a run......and I play well with others.