Recent content by Fyffer

Just returned last night from a 10 day trip just that area, pretty damned messy and many dirt roads are gone ( Crow Canyon, Combs and Butler wash) to include Moab. Dispersed camping got a little rough and real muddy. Pagosa springs is a bloody mess, got rerouted over Chama, La Manga vs over Wolf...

Thanks, cold night and AM for sure. Pissed we didn't get the Beaver dam blocking the Trail.

A great time, not without incidents myself.

Yes, use them. Drilling alignment is crucial. A MUD thread Frightening Discovery with Sano Recovery: Front Caliper Bolt Crisis @DrRock knows.

Nope, did go the timesert way. Reported as more reusable vs Helicoils from the U tube university. But also they were for my -71, 4 runner calipers I rebuilt for the 60. Yes, new bolts and a new brake line stick I had to bend. Sorting out my Frankie is not always that easy, PO did stuff.

Is Sheep ok?

Installed the kit, 100% easier than my previous one. Happier than SOS and id several previous problems from the one I had. Want to add I thought my sway bar extension kit was kaput, it wasnt ( really bent). A little more research showed mine and that the Man A Fee ones (@CruiserTrash favorite...

Had something similar going on, was not a fix all. But the front, rear shackle hanger mount was partially broken Driver side, on the very top outside only. I did not discover it until changing the spring pack. Got it welded ( if it's the case make sure there is a good alignment to the front) and...

So I just ordered the whole kit, 60UBFK-F, so that's that. Well then just the install :bang::worms:

Location does matter. Long story short, my U bolts need retorquing every time I'm under the rig. They've been in there properly since 2013 or few years later by PO. Had to use them even with a Trial of OME spring pack, so they have been off/on quite a few times. Centering pin has gotten bent in...

Chasing U bolts, Alcan Heavy duty spring pack, with a custom cut upper plate (at/close to specs) with 4* shims. Always got to spread top of bolts to fit the holes a .itch and for that reason need to be at least 9.3/4 " long, imo and in my situation. Found this site and looking at UBT 4061...

Also what's underneath, Catalytic converters in Tall (dry) grass, is also a High fire risk. A general FYI

Last year's bottle got either all used up or somebody kept it, what an idea :idea: Now I'm just sorting out a whistle in Tail pipe ;) after getting Hi Jack out of the rear:rofl: