Recent content by Fofifty

I finally got around to figuring this out. I ended up stripping the board of everything but the tactile buttons, put a coat of epoxy over all the open contacts except for the controls and then ran wires to connect one side of each switch in series followed by a resistor back to ground to...

Thanks, but I need the extended version. I have sound deadening and the OEM ones aren't long enough to fit. Wits end had some that were a little bit longer for that.

Anyone out there making the extended plastic nut for the step plate?

Are you still printing these? Interested in grabbing a set. Can you print them in the khaki color to match the interior?

Any update when you think you'll have some 80 racks ready?

Falcon Off-Road T8 17x9 -38mm Matte Gunmetal

That's awesome, keeping my fingers crossed I can score an 80 rack before my trip this fall.

If they pass I might be interested.

Awesome, I'll give you a call tomorrow.

If you're willing to work on a 96 LX450 I might be interested. I am having a tough time around CHS finding someone willing to swap my suspension bushings. I picked up a full OEM set along with brand new hardware but I don't have a press or a level enough area to feel comfortable leaving it on...

Awesome! Thanks

Dang, I wish the website was still up just so I could grab some part numbers. Even though nothing was typically in stock or it was overpriced, it was an easy way to figure out part numbers without sleuthing too much.

Looking to purchase, should I just send you shipping details via PM and send payment?

Got me too, haha

Thanks for your help! Can't wait to put on the parts.