Recent content by Fj80Ringo

when removing the backing plate, can you remove it with all of the parking brake parts still attached to it? I would love that!!

Good evening all! I snatched up a couple of axles with locking differentials and 4:56 gears. The axles were off of a 1991 HDJ81. I am getting ready to plug these in under my 97 FZJ80 and have a problem with the actuator fork and collar on the front differential. I removed the actuator from...

Did you ever figure out if the pinouts for the front were the same as the rear? I am doing the same thing right now.

Hello there!! I am with TN80. Some new keys would be RAD!!

Well written. That was fun to read. Good job.

Congratulations on your cruiser. You can download your factory service manual (FSM) rather than purchase one. Buy a spare fusible link and keep it in your rig. HAHA.

Way to go. I'll bet you are excited. I would be.

I'm in California. I wish I knew how I could pull this off here. BUT ill be watching for sure!!

They are Zero Offset.

I am not sure how the backspacing compares with the sequoia wheel. I am running 1.5" Spidertrax spacers on my rig with these wheels and tires. They are very close to 35" without a load on them. I have not measured them after putting them on.

17" Method 305's with Kenda Klever RT, 35x10.5

I like the look of those wheels. Does having the -12 offset put the outside of the tires even with the outside edge of your flare?

How in the heck do you get to the pivots? Do I have to take the dash apart to do it?

My brother and I installed the 10% underdrive Sumo Gears in our transfer cases a few weeks ago. I bought a cheap shop press from Harbor Freight and we got after it. We did not take the entire cases out. We took the backs off to get to the gear sets. The first one took us a while but the...