Recent content by FJ6T

Inbox purged.

Those look great!

Pretty simple.

I think I used black polycarbonate. I do have a Carbon Fiber infused polycarbonate filament I use for parts that are visible but the sheen/smooth finish of the standard PC seems to work well for the friction parts. I’ll attach the STL files here when I get home. Link to the latches?

Thank you. That’s a stock seat that I had reupholstered. I had them match the pattern of the Scheelman front seats.

I'm swapping my swap. I'm going to do erod ls3 connect and cruise. I considered selling the whole thing but I washed it this weekend and did a hot lap around the block and realized I could never sell it. But if that changes down the road, It will be CA compliant (at the time of this post) and...

Anyone thinking about a 5.3 conversion? I’m selling my setup with 5.3/H55F with Marks4x kit. The combo has approximately 50 miles on it. Pm me if interested.

I'd be up for a meet. In the past it, meetings were just a time and place with a parking lot big enough and tolerant enough for 10-20 60 series. Not much planning required for that.

I have the same unit from slcfj62. If you have power to the bussman fuse/relay box, check your original Fj fuse box for the headlight fuse and relay ( the round relays ). They drive the slcfj62 system for switching and dimming.

I'm not sure if these are still available but I definitely needed them. If you hate rattles you probably need them too. It's the bushing that goes in the 60/62 rear seatback pivot point. These combined with the @CruiserTrash rubber bump stops for the latch and the back seat is "almost" rattle...

Here's another update for anyone in the Portland area. Collision Auto Glass (Auto Glass Shop Portland | Collision Auto Glass & Calibration - https://collisionautoglass.com/) in Beaverton does a great job with 60/62 windshields. They do installs as well as reseals and do work with several local...

I didn't use the locking strip. I had a non locking strip gasket I bought from TLC4x4 a few years ago and have been waiting for right time to use it. Its made by precision gasket and I think you can get it from CityRacer or SOR. Most glass shops wont reuse the old gasket so keep that in mind. If...

Thanks! I dont have pics of the center caps off but they arent modified much. If I recall I started bending the spokes/tynes that grip the inside of the rim until it was a tight fit. I thought about having a groove machined inside of the rim when it was center bored but they already do not come...

Free - Anyone need a cargo or dome light lens/cover? I have the spares pictured below. Free to good home.

I knew what you meant... I installed it today and added a rear support strap. Reprinted the bezel in polycarb to resist the UV and heat.