Recent content by Fj40VBVA

Final result. 5 amp in-line fuse replaced and the fan is back and working. Does anyone know what the plug is for in the above pic

I believe the issue is with my carb cooling fan. Thanks for pointing me in the right direction. It does not seem to come on after turning off the ignition. I had no idea this existed. I know i need to test voltage before i pull anything out. Not sure if there is a controller or any fuses to...

I will give that a look tomorrow.

I can cold start my 40 the first drive with no issues. I pump the gas three times, pull the choke and she's up and running. When I have driven her for a while and then stop her to go into a store or for lunch and come back out to start her back up, she will not start. She cranks over, but...

Yes the control box, does DD provide enough wiring to get allow this easily vs being closer to the gauge cluster? do you have pics or videos of your install?

does it come with enough length to locate the terminal box this far away from the gauge?

Where did you place the DD plug in terminal ? Does it fit behind the cluster?

Were you able to place the DD wire panel behind the gauge cluster for install? Also was there any issue with the fuel tank configuration? Thanks in davance,

Did you ever finish the install of the DD cluster and get it working?

I know this an old thread, but how difficult was the fuel configuration? I ask because the instructions say " custom" and that youll need to remove the fuel tank sender etc.?

Brain are you still a rep? Your inbox is full.

Are you still. in VB? I just acquired my first FJ40. Looking for locals with similar interest and familiar with the trucks local..