Recent content by Evan Sturtevant

$6500 firm. Good things about this rig - I'd estimate I have just under 10K in extras added in....and i know you never get much value out of the add ons - Very clean body with Calvary Blue toyota paint job in 2019 ($3500) - Toyota white steelies all around with plenty of tread ($500) -...

1999 - rear tailgate Upper and lower. No rust. 1999-2003. Glass, seals, emblems & electrics all there. You'll need your own internal plastics and lock. These part are factory white with a black spray can paint job over the white. Again- no rust. These are cross posted on Ebay. Shipping...

Yah, thanks, now that i think about it...I think a big 1 inch spacer came off at the same time. Ok. Im going to get a after market kit and use the spacer (s) I have. Going Steel. Any recommendations?

This is a 2004 100 series...

Hi, I pulled this during my rust remediation project. Time to put on a new one. Anyone know the part number? If not..then what would you call it? Was near the front. Mine has a diff drop and 2.5 OME lift.

I need both front fenders and a cut out from rear driver quarter panel to replace my rusted pieces. if you are able to remove / ship, i can pay. Contact me at 206 734 8137

Hmmm.... thats a hole alright... that is boogie man i have spent so much time trykng to prevent. While i have dodged it thus far and hope to fend offthe rust monster(no road salt here)....i have to ask... what did you do to repair that? Was it expensive??? And did you find.more holes?

I have had my 2004 for about a month. My rust is same, maybe worse. After a lot of research, i took on the 1) removal step with mechanical: brush grinder, needle scaler(best), sanding belts(pull over frame rails, torsion), drills with wire brushes, then chemical: krud kutter 2) rust converter...

All my 2004 plastic splash guard "skid plates" are shot. I'd love a set of aluminum slee skid plates.. but will have to wait until the money falls from the sky. In the meantime, all the folks who may have upgraded to proper skid plates... probably have the old ones sitting around. I can pay...

I have this new [2004] 100 series. Did all the easy stuff (Subwoofer, AC line cap, heater T's, fluid changes etc..) I have 31's and 18 inch rims and next to a stock 100, I can see I have more wheel well clearance than the stock set up. I have been cleaning rust off the undercarriage for...

I have been thinking about this retro 100 [FJ100?] concept a lot. I conclude that the packaged Japan option is cost prohibitive. I also note that other car cultures all do retro mods. There is nothing proprietary about the concept or the mocked up photos. I think 4 design elements make it...

I need to put a new tailpipe on soon. For reference, what should I expect to pay...? Also...any idea where I can buy a resonator? thanks, Evan