Recent content by dlite460

**Update 4/8/2023** I've had a couple of issues worth mentioning post install of the Ironman FCP. After rolling around in the first 250-500 miles post install, I started to notice the front passenger leaning hard, like really hard. Thanks to these forums, I am thoroughly armed with...

User Deleted.

There are a lot of opinions out there on the number of turns to open the valves, 3 is often quoted as the maximum. I wonder if 3 turns is both the minimum and maximum for the fluid to flow freely when servicing...

Ordered the front spacer for my 2019 GX from Treaty Oak (I already installed spacers on the rear that came with the Ironman FCP kit)... front spacer didn't elminate my lean at all. I was really looking forward to that 1/4 inch margin. :bang:

Everytime I see this green, man, I think DA*N - I want that! Looking good, sir!

Did you have any lean issues after the lift install? Mine is clocked at just about 1" to the passenger side, all signs point to the lean being there prior to my lift install... ignorance was bliss while it lasted... lol

Appreciate it. Really owe all the credit to TEQ, he really guided my decisions on the lift. Screenshot of my exact setup attached. Went with Apache Offroad UCA's - didn't want Uni-ball, and maintenance-free is nice and all, but I like to be able to be able to service my UCA's with a wittle...

I had adjusted clamps, took it apart too many times to count, reset the rubber hangers, twisted and turned the exhaust pipes... literally adjusted everything that connects the exhaust due to clearance and fitment issues for the piece that routes over the rear differential assembly. No matter...

I went back and forth on this, ALOT. It came down to me knowing my limits, and once you start that cutting process there is no turning back. Ultimately, I had the shop do it while they were installing the lift - they do it all the time and it just made sense to me to have someone with...

LOL... ya, this is definately on my mind now; especially since I ripped out that dumbA$$ magnaflow overland exhaust system!

Added some frills this week... me likey (:

10/10 Reccomend Teq Auto Solutions & Offroad in east HTX. Jesus aka Jeboost went above and beyond what he could have; couldn't have asked for a better experience.

I've got my wee little eyes on those for sure! They're sold out atm - so I'm currently be watching and waiting. Lengthwise, do the Slee run the whole length of the OEM running board, or are they centered? Do you have any pics you can share of the whole side of your GX? Looks like you have the...

I think I saw your post in this thread from Summit site on the APEX sliders. What mods did you have to make to the slider to install?

I like the idea of getting the "widest ones available" but this is proving to be most certainly easier said than done. In my experience, it has been very difficult to find sliders that serve dual purpose of a step (and I mean an adequate step - plenty advertise as a step but fall short...