I changed the battery in my FOB and now only the lock button on the FOB is working. I tried the steps in the original post and at step 8 I only get one cycle vs. five. When I continue on I get the two cycles after programming noting that it failed. Anyone have any thoughts or suggestions about...
Took it to a local shop for them to diagnose. Turns out it was the harness and not the amp. They have it all running now, but unfortunately they closed early and when I picked up my truck it has the interference hiss. I bet they re-wired everything and used the speaker outputs from my head unit...
I
I looked to see if any fuses looked broken. Nothing stood out but I may just change the cig fuse to be sure.
I may just need to bypass the amp and run the speakers off the head unit until I figure out what I want to do.
It was connected. I had undone it and reconnected it to test. Pulled everything apart again to run the USB and forgot because my kids were visiting me while working and distracting me. Stupid mistake I know.
The noise was when I connected the pre-amp which is why I think it is an issue at the...
It’s definitely not getting power. The yellow wire showed no voltage. I pulled the 12v and light off the cigarette lighter and covered the connections with electrical tape. It’s on its own fuse so I am not sure it would cause the issue. The other 12v on the right is fine as well. I heard some...
Did my install today. Halfway through I tested the harness and all powered up and sounded okay. Wired up my USB plug to replace the cigarette lighter, put everything back together, and now there’s no power. The 20A fuse under the hood is fine and I replaced it to be sure. Tried plugging the...